MAX4784EUE+T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 1Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 755mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 4 |
| Supply Voltage | 1.8V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | MAX4784 |
| Pin Count | 16 |
| Operating Supply Voltage | 3V |
| Number of Channels | 2 |
| Number of Circuits | 4 |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 1.6V |
| Operating Supply Current | 2μA |
| Turn On Delay Time | 30 ns |
| Logic Function | Multiplexer |
| Supply Type | Single |
| Bandwidth | 123MHz |
| Turn-Off Delay Time | 15 ns |
| On-State Resistance (Max) | 1Ohm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 33pF 60pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 25ns, 10ns |
| Charge Injection | 5pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -95dB @ 1MHz |
| Switching | BREAK-BEFORE-MAKE |
| Voltage - Supply, Single (V+) | 1.6V~4.2V |
| Signal Current-Max | 0.15A |
| Height Seated (Max) | 1.1mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
MAX4784EUE+T Overview
This electronic part is conveniently packaged in 16-TSSOP (0.173, 4.40mm Width), making it easy to ship abroad. This packaging method provides high reliability because it uses advanced packaging techniques. Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 2:1. Extended operating temperature around -40°C~85°C TA. In total, 16 terminations have occurred. A high-quality output is provided by the electrical component's 2 channels. When the electronic component is given a voltage of 1.8V, it should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. A SPDT switching circuit is used for these analog switches. There are 4 circuits in this multiplexer. Try searching with MAX4784 to find analog multiplexer variants. As far as internal resistance is concerned, it has 1Ohm. Datasheets for 16 pin functions are available upon request. An abnormal situation would be for the switch device to be supplied with a voltage greater than 3.6V. The digital multiplexer has a low cost Single supply. It is recommended to use 1.6V as the lowest voltage for the electrical part. 2μA current would be enough for this multiplexer to operate. A voltage of 1.6V~4.2V is required to drain this analog switch from a single voltage supply. It can operate from 3V operating voltages. 123MHz-bandwidths can be used to transfer data between multiplexers.
MAX4784EUE+T Features
2 Channels
Switch Circuit: SPDT
2μA Supply Current
Bandwidth: 123MHz
MAX4784EUE+T Applications
There are a lot of Maxim Integrated MAX4784EUE+T Analog Switches & Multiplexers ICs applications.
- Battery Powered Systems
- High speed data transmission line cards
- PDH Multiplexers
- Low-Voltage
- Communications systems
- Access Concentrators
- E1 Multiplexer
- SDH/SONET multiplexers
- Video signal routing
- Microprocessor controlled systems
