MAX4993ELB+T
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-WFDFN |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2009 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| ECCN Code | EAR99 |
| Resistance | 500mOhm |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX4993 |
| Operating Supply Voltage | 5V |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.8V |
| Nominal Supply Current | 3.1mA |
| Max Supply Current | 8.5mA |
| Turn On Delay Time | 360 ms |
| Supply Type | Single |
| Turn-Off Delay Time | 500 ns |
| On-State Resistance (Max) | 500mOhm |
| Multiplexer/Demultiplexer Circuit | 2:2 |
| Current - Leakage (IS(off)) (Max) | 100nA |
| Channel Capacitance (CS(off), CD(off)) | 45pF |
| Switch Circuit | DPDT |
| Switch Time (Ton, Toff) (Max) | 630ns, 2μs |
| Channel-to-Channel Matching (ΔRon) | 3m Ω |
| Crosstalk | -110dB @ 20kHz |
| Voltage - Supply, Single (V+) | 1.8V~5.5V |
| RoHS Status | ROHS3 Compliant |
MAX4993ELB+T Overview
Due to its 10-WFDFN packaging, the electronic part is convenient for international shipping. To ensure high reliability, a new packaging method Tape & Reel (TR) is used. A switch device like this is mounted in Surface Mount. The ratio between the number of multiplexer and demultiplexer circuits is 2:2. Operational temperature extended around -40°C~85°C TA. DPDT switching circuits are used in these analog switch ics. 1 circuits are used in this analogue multiplexer. Search with MAX4993 if you are looking for analog multiplexer variants. This digital multiplexer has 500mOhm internal resistance. It is generally not recommended to supply a voltage higher than 5.5V to the switch device in normal circumstances. Single supply type digital switch with a low cost. The lowest voltage the electronic part should receive is 1.8V. This analog switch requires a voltage of 1.8V~5.5V to drain from a single voltage supply. When the digital multiplexer is charged above 8.5mA, damage can occur. It can operate from 5V operating voltages.
MAX4993ELB+T Features
Switch Circuit: DPDT
MAX4993ELB+T Applications
There are a lot of Maxim Integrated MAX4993ELB+T Analog Switches & Multiplexers ICs applications.
- E1 Network Equipment
- FTTH
- E1 Multiplexer
- Industrial control systems
- SONET/SDH ADM
- Cell phones
- Multiplexers
- Central office
- Automatic test equipment
- Ultrasound
