MAX704RCPA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Through Hole |
| Package / Case | DIP |
| Number of Pins | 8 |
| Packaging | Tube |
| Published | 2006 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Type | Battery Backup Circuit |
| Terminal Finish | Matte Tin (Sn) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | Power Management Circuits |
| Max Power Dissipation | 727mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Terminal Pitch | 2.54mm |
| Pin Count | 8 |
| Power Supplies | 3/5V |
| Temperature Grade | COMMERCIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1V |
| Operating Supply Current | 50μA |
| Adjustable Threshold | NO |
| Watchdog Timer | No |
| Reset | Active Low |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140 ms |
| Supply Current-Max (Isup) | 0.05mA |
| Min Reset Threshold Voltage | 2.55V |
| Max Reset Threshold Voltage | 2.72V |
| Threshold Voltage | 2.625V |
| Undervoltage Threshold | 2.55V |
| Overvoltage Threshold | 2.72V |
| Height Seated (Max) | 4.572mm |
| Length | 9.375mm |
| Width | 7.62mm |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX704RCPA+ Overview
As you can see, this power management is mounted through 8 terminals. In terms of packaging, power management follows the Tube model. Please refer to this PMIC for 1 functions. This power management is made up of 1 channels which are available in a series format. In this IC management you will find DIP functions for you to refer to. It is a IC power that shares many benefits with other products from the Battery Backup Circuit line. According to the specification, the package's peak reflow temperature is specified to be 260. Power management conducts at a voltage of 1. Through Hole is the one that mounts power management. There is a subcategory called Power Management Circuits for this power management. In total, it has 8 pins on IC management. There are 8 pins on the power managment ic. It is recommended that Vsup should not be less than 1V for this IC power. The maximum supply voltage (Vsup) in this PMIC should not exceed 5.5V volts. The power management's supply current is 50μA. It requires 3/5V watts of power to operate this voltage supervisor.
MAX704RCPA+ Features
Battery Backup Circuit type
Minimum supply voltage of 1V
50μA operating supply current
MAX704RCPA+ Applications
There are a lot of Maxim Integrated MAX704RCPA+ Voltage Supervisors applications.
- Urban rail transit weak current power monitoring
- Power communication system
- Electrical fire monitoring system
- Important electronics for automotive protection
- Data storage applications
- Dash board
- Insulation fault location system
- Fire equipment power monitoring system
- Microprocessor system
- Leakage current detection
