MAX707EPA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2013 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Type | Simple Reset/Power-On Reset |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Power Management Circuits |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX707 |
| Output | Push-Pull, Push-Pull |
| Pin Count | 8 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Number of Channels | 2 |
| Adjustable Threshold | YES |
| Reset | Active High/Active Low |
| Voltage - Threshold | 4.65V |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140ms Minimum |
| Supply Current-Max (Isup) | 0.5mA |
| Height Seated (Max) | 4.572mm |
| Length | 9.375mm |
| Width | 7.62mm |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX707EPA+ Overview
As far as the mounting terminals of this voltage supervisor are concerned, it has 8 in total. Tube-packaging is used. Please find attached 1 functions for your reference in this IC power. On this supervisor, there is a series of 2 channels that can be found. Please refer to power management for 8-DIP (0.300, 7.62mm) functions. There are a lot of similarities between this IC management and other Simple Reset/Power-On Reset products. There is a specification for the peak reflow temperature of the package to be 260. A supply voltage of 5V is used to conduct the PMIC chip. Power management conducts at a voltage of 1. The power management system can be categorized as a Power Management Circuits chip. In total, IC powers are 8 pins on the board. 8 pins are on the supervisor. The recommended mounting type for IC management is Through Hole. The supervisors should be set to the following temperature: -40°C~85°C TA. Power management has an output of Push-Pull, Push-Pull during operation. You can always use MAX707, the base supervisor number, to search for similar PMICs of the manufacturer. It is necessary to have 5V volts of power in order for this voltage supervisor to operate.
MAX707EPA+ Features
Simple Reset/Power-On Reset type
MAX707EPA+ Applications
There are a lot of Maxim Integrated MAX707EPA+ Voltage Supervisors applications.
- Detection of phase sequence
- Sensitive sensors
- Battery-powered equipment
- Unattended substation automation
- Precision measurement
- WiFi router
- Utility meter
- Important electronics for automotive protection
- Power distribution systems of CCU
- Military communications
