MAX894LESA+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2007 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX894 |
| Pin Count | 8 |
| Number of Outputs | 2 |
| Qualification Status | Not Qualified |
| Output Voltage | 5V |
| Output Type | P-Channel |
| Input Voltage-Nom | 5V |
| Interface | On/Off |
| Analog IC - Other Type | DUAL SWITCHING CONTROLLER |
| Current - Output (Max) | 500mA |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | General Purpose |
| Input Voltage (Max) | 5.5V |
| Supply Current-Max (Isup) | 0.05mA |
| Switcher Configuration | BOOST |
| Ratio - Input:Output | 1:2 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Adjustable), Over Temperature |
| Rds On (Typ) | 120m Ω |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MAX894LESA+ Overview
As a result, it is packaged in the form of a Tube.It is included with the 8-SOIC (0.154, 3.90mm Width) package as well.The lighting driver has the mounting type Surface Mount.There is a General Purpose switch type associated with it.It is recommended to set the temperature to -40°C~85°C TA in order to ensure reliable operation.The LED driver is equipped with 2 outputs.A voltage of Not Required is used to power it.Voltage output is P-Channel volts at maximum.As you can see, it comes from the MAX894 family.A total of 8 terminations have been found in it.For operation, 8 pins are used.The LED driver has 1 functions.Its maximum output voltage is 500mAV.The LED driver has a total of 8 pins.This LED driving board uses an analog IC DUAL SWITCHING CONTROLLER.In order to operate at its maximum capacity, the supply current must not exceed 0.05mA.
MAX894LESA+ Features
MAX894LESA+ Applications
There are a lot of Maxim Integrated MAX894LESA+ Power Switches ICs applications.
- Gaming
- HDD, SSD
- Portable GPS
- Hard Disk Drives
- USB Power Distribution
- Low Voltage I/O System Power
- Handheld Devices
- Solid State Drivers
- Notebook and Tablet Computers
- Wearable Devices
