MAX9610FELT+T
| Parameters | |
|---|---|
| RoHS Status | ROHS3 Compliant |
| Factory Lead Time | 1 Week |
| Contact Plating | Gold |
| Surface Mount | YES |
| Number of Pins | 6 |
| Packaging | Strip |
| Published | 2010 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Other Analog ICs |
| Max Power Dissipation | 168mW |
| Technology | BICMOS |
| Terminal Position | BOTTOM |
| Number of Functions | 1 |
| Supply Voltage | 3.6V |
| Terminal Pitch | 0.5mm |
| Pin Count | 6 |
| Temperature Grade | INDUSTRIAL |
| Number of Channels | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.6V |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 750nA |
| Adjustable Threshold | NO |
| Common Mode Rejection Ratio | 104 dB |
| Input Offset Voltage (Vos) | 100μV |
| Bandwidth | 170 kHz |
| -3db Bandwidth | 110 kHz |
| Height Seated (Max) | 0.8mm |
| Radiation Hardening | No |
MAX9610FELT+T Overview
It comes in a Strip case, which protects instrumentation amplifier from damage during delivery. During the past two weeks, there have been close to 6 terminations. A total of 6 pins are located on this board. The linear amplifier should be run at 3.6V at all times, so please keep that in mind when using it. In more specific terms, this linear amplifier can be categoriOther Analog ICsed as a Other Analog ICs-type device. There are 6 pins on this chip. There is an input offset voltage of 100μV for this buffer op amp. It is possible to operate this buffer amplifier from a supply current of 750nA . Op amp ic has 1 channels. For this linear amplifier to work, the temperature should not be below -40°C. A temperature greater than 85°C should not be used for the operation of buffer amplifier. With regard to the supply voltage, this electrical component is capable of working from under 5.5V. As a rule of thumb, the supply voltage of the op amp should not be lower than 1.6V. Besides the analog ICs used in this instrumentation amplifier, there is also another type of analog IC called POWER SUPPLY SUPPORT CIRCUIT IC.
MAX9610FELT+T Features
6 Pins
supply voltage of 3.6V
MAX9610FELT+T Applications
There are a lot of Maxim Integrated MAX9610FELT+T Instrumentational OP Amps applications.
- ECG equipment
- Non-polarized electrodes
- Gaming industry
- Multimedia playback equipment
- Fast A/D and D/A converters
- Signal operation
- Automotive sensors
- Subtraction operation circuits
- Video data acquisition
- Micro signal measurement
