MAX9610TELT+T
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 6-WDFN |
| Surface Mount | YES |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tape & Reel (TR) |
| Published | 2010 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Subcategory | Other Analog ICs |
| Max Power Dissipation | 168mW |
| Technology | BICMOS |
| Terminal Position | BOTTOM |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 3.6V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX9610 |
| Pin Count | 6 |
| Qualification Status | Not Qualified |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 750nA |
| Adjustable Threshold | NO |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 104 dB |
| Voltage - Supply, Single/Dual (±) | 1.6V~5.5V |
| Input Offset Voltage (Vos) | 100μV |
| -3db Bandwidth | 170kHz |
| Height Seated (Max) | 0.8mm |
| RoHS Status | ROHS3 Compliant |
MAX9610TELT+T Overview
In the package, you will find a 6-WDFN-case to contain the op amp ic. This is a Current Sense type op amp. There is a Tape & Reel (TR) case that is delivered with the instrumentation amplifiers. It is estimated that there will be 6 terminations in the next few months. The pins on this board total to 6 in total. Please take in mind that op amp should be run at 3.6V. A type of Other Analog ICs buffer op amp is what this device is specifically, to be more precise. The buffer op amp includes 6 pins. There is an input offset voltage of 100μV for this buffer op amp. For this electrical component, Surface Mount is the recommended mounting type. In relation to the operating temperature of this buffer op amp, it works well at an average of -40°C~85°C . It is possible to operate this buffer amplifier from a supply current of 750nA . There are 1 circuits on this op amp. 1 channels are available on the instrumentation amplifier. This linear amplifier also utiliPOWER SUPPLY SUPPORT CIRCUITes an analog IC known as a POWER SUPPLY SUPPORT CIRCUIT.
MAX9610TELT+T Features
6 Pins
supply voltage of 3.6V
MAX9610TELT+T Applications
There are a lot of Maxim Integrated MAX9610TELT+T Instrumentational OP Amps applications.
- Division circuits
- Signal amplification
- Signal transformation
- Semiconductor detectors
- Multiplication circuits
- Medical imaging
- Weak signal detection
- Radiation thermometry transducers
- Commercial audio systems
- ECG equipment
