MAX9923FEUB+
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Number of Pins | 10 |
| Operating Temperature | -40°C~85°C |
| Packaging | Tube |
| Published | 2010 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Subcategory | Operational Amplifier |
| Max Power Dissipation | 362mW |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Base Part Number | MAX9923 |
| Pin Count | 10 |
| Qualification Status | Not Qualified |
| Power Supplies | 3.3V |
| Number of Circuits | 1 |
| Operating Supply Current | 780μA |
| Slew Rate | 0.4V/μs |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 140 dB |
| Current - Input Bias | 1pA |
| Voltage - Supply, Single/Dual (±) | 2.85V~5.5V |
| Input Offset Voltage (Vos) | 100nV |
| Power Supply Rejection Ratio (PSRR) | 99dB |
| Supply Voltage Limit-Max | 6V |
| Voltage - Input Offset | 0.1μV |
| -3db Bandwidth | 2.5kHz |
| Length | 3mm |
| RoHS Status | ROHS3 Compliant |
MAX9923FEUB+ Overview
The linear amplifier is packaged in a 10-TFSOP, 10-MSOP (0.118, 3.00mm Width) case. There are two types of operational amplifiers in this circuit. A Tube case is used to deliver the buffer op amp. A total of 10 terminations have been reported in the past few weeks. The total number of pins on linear amplifier is 10. I would like you to keep in mind that this buffer amplifier needs to be run at a voltage of 3.3V. It should be noted that this type of buffer amplifier is exactly what is known as a Operational Amplifier device. 10 pins are located on the operational amplifiers. The input offset voltage is 100nV. For this electronic part, it is recommended that you mount it with type Surface Mount. In terms of operating temperatures, this buffer amplifier works very well at a temperature of around -40°C~85°C . As long as the supply current of the chip does not exceed 780μA, this op amp ic can operate. This op amp ic has 1 circuits.
MAX9923FEUB+ Features
10 Pins
supply voltage of 3.3V
MAX9923FEUB+ Applications
There are a lot of Maxim Integrated MAX9923FEUB+ Instrumentational OP Amps applications.
- Power transmission
- Differentiator circuits
- Blood pressure sensors
- E-book readers
- Ultrasound transducers
- Inverse/same-phase proportional circuit
- Vehicle electronics
- Power generator
- Navigation
- Hand-held batteries
