MB39A135PFT-G-JN-ERE1
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Supplier Device Package | 16-TSSOP |
| Operating Temperature | -30°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2014 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -30°C |
| Function | Step-Down |
| Number of Outputs | 1 |
| Output Voltage | 3.36V |
| Output Type | Transistor Driver |
| Operating Supply Voltage | 25V |
| Min Supply Voltage | 4.5V |
| Operating Supply Current | 2.7mA |
| Output Configuration | Positive |
| Output Current | 60mA |
| Voltage - Supply (Vcc/Vdd) | 4.5V~25V |
| Control Features | Current Limit, Power Good, Soft Start |
| Topology | Buck |
| Min Input Voltage | 4.5V |
| Frequency - Switching | 100kHz~780kHz |
| Max Input Voltage | 25V |
| Synchronous Rectifier | Yes |
| Min Output Voltage | 700mV |
| Clock Sync | No |
| Output Phases | 1 |
| Number of Output Phases | 1 |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
MB39A135PFT-G-JN-ERE1 Overview
In the 16-TSSOP (0.173, 4.40mm Width) package, the switching controller meets most application requirements. There is enough capacity in the dc motor controller to generate the output for the 1 input. Packaged in solid enclosures, this pmic has a Tape & Reel (TR) rating. Transistor Driver dc switching's outputs (s) are supported. DC control operates at 4.5V~25V volts and has 4.5V~25V supply voltage. Suitable for a -30°C~85°C TA dc switcher. This switching controller can switch at 100kHz~780kHz. A generalization of dc dc regulator can be made using Surface Mount. Switching control is made easier with the dcdc regulator's Current Limit, Power Good, Soft Start. 16 pins are on switching converter. A 3.36V voltage of DC regulator was detected in the test statistics. normally, the dc dc regulator's output current is 60mA, which you should keep in mind when starting a project. As DC switcher has a Surface Mount, it's suitable for most applications and prototype designs. It is suggested that users apply 25V to the voltage regulator dc to dc in order to run it safely and reliably in a circuit. Ideally, dc regulator should be kept at a temperature of -30°C or higher. A temperature of 85°C degrees Celsius is recommended. The maximum input voltage of the dc switcher is 25V, so users need to limit the voltage accordingly. The supplier dc dc controller package for this part would be 16-TSSOP. A voltage of 4.5V must be present in the supply. With a current supply of 2.7mA, it runs. The voltage controller's lowest voltage output is not less than 700mV. This controller contains 1 phases.
MB39A135PFT-G-JN-ERE1 Features
Transistor Driver Outputs
Switching Frequency: 100kHz~780kHz
Current Limit, Power Good, Soft Start
MB39A135PFT-G-JN-ERE1 Applications
There are a lot of Cypress Semiconductor Corp MB39A135PFT-G-JN-ERE1 DC to DC converter applications.
- Imported equipment
- Medical equipment
- Geothermal power
- Textile machinery
- Photovoltaic power
- Overvoltage protection circuits in TV sets
- Computer monitoring equipment of building
- Program control systems
- Handheld GPS
- Current source circuits
