MC100EP451FAR2
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 32-LQFP |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Series | 100EP |
| JESD-609 Code | e0 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 32 |
| Type | D-Type |
| Terminal Finish | TIN LEAD |
| Additional Feature | NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V |
| Technology | ECL |
| Voltage - Supply | 3V~5.5V |
| Terminal Position | QUAD |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.8mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| JESD-30 Code | S-PQFP-G32 |
| Function | Master Reset |
| Qualification Status | COMMERCIAL |
| Output Type | Differential |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 3V |
| Clock Frequency | 3GHz |
| Current - Quiescent (Iq) | 135mA |
| Output Polarity | COMPLEMENTARY |
| Number of Bits per Element | 6 |
| Trigger Type | Positive Edge |
| Propagation Delay (tpd) | 0.55 ns |
| Length | 7mm |
| Width | 7mm |
| RoHS Status | Non-RoHS Compliant |
MC100EP451FAR2 Overview
The flip flop is packaged in 32-LQFP. It is contained within the Tape & Reel (TR)package. T flip flop uses Differentialas its output configuration. It is configured with a trigger that uses a value of Positive Edge. Surface Mountis positioned in the way of this electronic part. A voltage of 3V~5.5Vis required for its operation. Temperature is set to -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. JK flip flop belongs to the 100EPseries of FPGAs. Its output frequency should not exceed 3GHz. A total of 1elements are contained within it. T flip flop consumes 135mA quiescent energy. Currently, there are 32 terminations. An input voltage of 3.3Vpowers the D latch. The maximal supply voltage (Vsup) reaches 5.5V. For normal operation, the supply voltage (Vsup) should be above 3V. Additionally, there are NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V on the electronic flip flop that can be referred to.
MC100EP451FAR2 Features
Tape & Reel (TR) package
100EP series
MC100EP451FAR2 Applications
There are a lot of Rochester Electronics, LLC MC100EP451FAR2 Flip Flops applications.
- Synchronous counter
- Latch
- Modulo – n – counter
- Memory
- Individual Asynchronous Resets
- Instrumentation
- 2 – Bit synchronous counter
- Communications
- Reduced system switching noise
- ESCC
