MC10EP35DTG
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 8-TSSOP, 8-MSOP (0.118, 3.00mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 10EP |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 8 |
| Type | JK Type |
| Terminal Finish | MATTE TIN |
| Additional Feature | NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V |
| Technology | ECL |
| Voltage - Supply | -3V~-5.5V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Supply Voltage | 3.3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| JESD-30 Code | S-PDSO-G8 |
| Function | Reset |
| Qualification Status | COMMERCIAL |
| Output Type | Differential |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 5.5V |
| Supply Voltage-Min (Vsup) | 3V |
| Number of Bits | 2 |
| Clock Frequency | 3GHz |
| Family | 10E |
| Current - Quiescent (Iq) | 50mA |
| Output Polarity | COMPLEMENTARY |
| Trigger Type | Positive Edge |
| Propagation Delay (tpd) | 0.49 ns |
| Length | 3mm |
| Width | 3mm |
| RoHS Status | ROHS3 Compliant |
MC10EP35DTG Overview
The package is in the form of 8-TSSOP, 8-MSOP (0.118, 3.00mm Width). As part of the package Tube, it is embedded. As configured, the output uses Differential. There is a trigger configured with Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The JK flip flop operates at a voltage of -3V~-5.5V. It is operating at a temperature of -40°C~85°C TA. It belongs to the type JK Typeof flip flops. In this case, it is a type of FPGA belonging to the 10EP series. Its output frequency should not exceed 3GHz Hz. The list contains 1 elements. As a result, it consumes 50mA quiescent current and is not affected by external forces. 8terminations have occurred. An input voltage of 3.3Vpowers the D latch. In terms of electronic devices, this device belongs to the 10Efamily of devices. There are 2bits in this flip flop. 5.5Vis the maximum supply voltage (Vsup). Normally, the supply voltage (Vsup) should be above 3V. Additionally, there are NECL MODE: VCC = 0V WITH VEE = -3V TO -5.5V on the electronic flip flop that can be referred to.
MC10EP35DTG Features
Tube package
10EP series
2 Bits
MC10EP35DTG Applications
There are a lot of Rochester Electronics, LLC MC10EP35DTG Flip Flops applications.
- Single Down Count-Control Line
- Shift Registers
- Dynamic threshold performance
- Storage registers
- High Performance Logic for test systems
- Divide a clock signal by 2 or 4
- Set-reset capability
- Safety Clamp
- Bus hold
- Clock pulse
