MC10H135MG
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.209, 5.30mm Width) |
| Number of Pins | 16 |
| Operating Temperature | 0°C~75°C TA |
| Packaging | Tube |
| Published | 2006 |
| Series | 10H |
| JESD-609 Code | e4 |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Type | JK Type |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | FF/Latches |
| Packing Method | RAIL |
| Technology | ECL |
| Voltage - Supply | -4.9V~-5.46V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | 10H135 |
| Function | Set(Preset) and Reset |
| Qualification Status | Not Qualified |
| Output Type | Differential |
| Polarity | Non-Inverting |
| Number of Circuits | 2 |
| Clock Frequency | 250MHz |
| Propagation Delay | 2.6 ns |
| Turn On Delay Time | 1 ns |
| Family | 10H |
| Logic Function | AND, Flip-Flop |
| Current - Quiescent (Iq) | 68mA |
| Number of Bits per Element | 1 |
| Trigger Type | Positive Edge |
| Power Supply Current-Max (ICC) | 75mA |
| Number of Input Lines | 4 |
| Clock Edge Trigger Type | Positive Edge |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
MC10H135MG Overview
The flip flop is packaged in a case of 16-SOIC (0.209, 5.30mm Width). The Tubepackage contains it. T flip flop uses Differentialas its output configuration. This trigger uses the value Positive Edge. This electronic part is mounted in the way of Surface Mount. The supply voltage is set to -4.9V~-5.46V. A temperature of 0°C~75°C TAis used in the operation. It is an electronic flip flop with the type JK Type. It belongs to the 10Hseries of FPGAs. This D flip flop should not have a frequency greater than 250MHz. As a result, it consumes 68mA of quiescent current without being affected by external factors. There are 16 terminations,This D latch belongs to the family of 10H135. It is a member of the 10Hfamily of D flip flop. It is mounted in the way of Surface Mount. There are 16pins on it. This device exhibits a clock edge trigger type of Positive Edge. The part is included in FF/Latches. The superior flexibility of this product is achieved by using 2 circuits. On the basis of its reliable performance, this D flip flop is well suited for use with RAIL. As of now, there are 4input lines.
MC10H135MG Features
Tube package
10H series
16 pins
MC10H135MG Applications
There are a lot of ON Semiconductor MC10H135MG Flip Flops applications.
- EMI reduction circuitry
- Load Control
- Latch
- Shift registers
- ESD protection
- Frequency Dividers
- Circuit Design
- High Performance Logic for test systems
- Data Synchronizers
- Counters
