Parameters |
Mounting Type |
Through Hole |
Package / Case |
16-DIP (0.300, 7.62mm) |
Surface Mount |
NO |
Operating Temperature |
0°C~75°C |
Packaging |
Tube |
Series |
10H |
JESD-609 Code |
e3 |
Pbfree Code |
no |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
3 (168 Hours) |
Number of Terminations |
16 |
Terminal Finish |
MATTE TIN |
Technology |
ECL |
Voltage - Supply |
4.94V~5.46V |
Terminal Position |
DUAL |
Peak Reflow Temperature (Cel) |
260 |
Number of Functions |
1 |
Terminal Pitch |
2.54mm |
Reach Compliance Code |
unknown |
Time@Peak Reflow Temperature-Max (s) |
40 |
Pin Count |
16 |
Qualification Status |
COMMERCIAL |
Output Type |
Tri-State |
Circuit |
5:5 |
Number of Bits |
5 |
Family |
10H |
Output Characteristics |
OPEN-EMITTER |
Logic Type |
D-Type Transparent Latch |
Output Polarity |
TRUE |
Trigger Type |
LOW LEVEL |
Independent Circuits |
1 |
Delay Time - Propagation |
1ns |
Height Seated (Max) |
4.44mm |
Width |
7.62mm |
RoHS Status |
ROHS3 Compliant |
MC10H175PG Overview
It is embedded in the 16-DIP (0.300, 7.62mm) package. Tube is the packaging method. Tri-State is used for the output it is configured with. There is a logic type of D-Type Transparent Latch for this electrical device. Through Hole is used to mount this electronic part. A 4.94V~5.46V supply voltage is required to operate it. The operating temperature is 0°C~75°C. The 10H series of FPGAs is the one this FPGA belongs to. It is designed with 5 bits. In this device, there are 16 terminations. It has 16 pins that makes it easy to use. 10H is the family of this electronic device.
MC10H175PG Features
16-DIP (0.300, 7.62mm) package
10H series
5 Bits
16 pin count
MC10H175PG Applications
There are a lot of Rochester Electronics, LLC MC10H175PG Latches applications.
- Counting
- Control circuits
- Motor Drives
- Automatic test equipment
- Automotive HEV/EV Powertrain
- Bus system register with enable parallel lines at bus side
- Double bus register system
- Avionics
- OC-48 communication systems
- Four-bit storage with output enable