MC74AC377DW
| Parameters | |
|---|---|
| Current - Output High, Low | 24mA 24mA |
| Output Polarity | TRUE |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 10ns @ 5V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 4.5pF |
| Height Seated (Max) | 2.65mm |
| Width | 7.5mm |
| RoHS Status | Non-RoHS Compliant |
| Mounting Type | Surface Mount |
| Package / Case | 20-SOIC (0.295, 7.50mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Series | 74AC |
| JESD-609 Code | e0 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 20 |
| Type | D-Type |
| Terminal Finish | TIN LEAD |
| Technology | CMOS |
| Voltage - Supply | 2V~6V |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Supply Voltage | 5V |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| JESD-30 Code | R-PDSO-G20 |
| Function | Standard |
| Qualification Status | COMMERCIAL |
| Output Type | Non-Inverted |
| Number of Elements | 1 |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2V |
| Clock Frequency | 140MHz |
| Family | AC |
| Current - Quiescent (Iq) | 8μA |
MC74AC377DW Overview
In the form of 20-SOIC (0.295, 7.50mm Width), it has been packaged. It is contained within the Tubepackage. The output it is configured with uses Non-Inverted. This trigger is configured to use Positive Edge. In this case, the electronic component is mounted in the way of Surface Mount. The supply voltage is set to 2V~6V. A temperature of -40°C~85°C TAis considered to be the operating temperature. Logic flip flops of this type are classified as D-Type. In terms of FPGAs, it belongs to the 74AC series. A frequency of 140MHzshould be the maximum output frequency. In total, there are 1 elements. Despite external influences, it consumes 8μAof quiescent current. In 20terminations, a transmission line is terminated with a JK flip flop that matches its characteristic impedance. The power supply voltage is 5V. The input capacitance of this T flip flop is 4.5pF farads, which is defined as the capacitance between the input terminals of an op amp with either input grounded. In this case, the D flip flop belongs to the ACfamily. It reaches 6Vwhen the supply voltage is maximal (Vsup). If you want to maintain normal operation, you should keep the supply voltage (Vsup) above 2V.
MC74AC377DW Features
Tube package
74AC series
MC74AC377DW Applications
There are a lot of Rochester Electronics, LLC MC74AC377DW Flip Flops applications.
- Event Detectors
- Set-reset capability
- Pattern generators
- Differential Individual
- Storage Registers
- Test & Measurement
- Latch
- ATE
- Parallel data storage
- 2 – Bit synchronous counter
