Parameters |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
14-SOIC (0.209, 5.30mm Width) |
Number of Pins |
14 |
Operating Temperature |
-55°C~85°C TA |
Packaging |
Tube |
JESD-609 Code |
e4 |
Part Status |
Obsolete |
Moisture Sensitivity Level (MSL) |
3 (168 Hours) |
Number of Terminations |
14 |
Resistance |
30Ohm |
Terminal Finish |
Nickel/Palladium/Gold (Ni/Pd/Au) |
Subcategory |
Multiplexer or Switches |
Technology |
CMOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Number of Functions |
4 |
Supply Voltage |
3V |
Terminal Pitch |
1.27mm |
Reach Compliance Code |
unknown |
Base Part Number |
MC74LVXT4066 |
Output |
SEPARATE OUTPUT |
Pin Count |
14 |
Qualification Status |
Not Qualified |
Operating Supply Voltage |
5V |
Power Supplies |
3.3V |
Number of Channels |
1 |
Number of Circuits |
4 |
Max Supply Voltage |
5.5V |
Min Supply Voltage |
2V |
Operating Supply Current |
40μA |
Max Supply Current |
4μA |
Throw Configuration |
SPST |
Turn On Delay Time |
20 ns |
Logic Function |
Demultiplexer, Multiplexer |
Supply Type |
Single |
Turn-Off Delay Time |
30 ns |
-3db Bandwidth |
160MHz |
On-State Resistance (Max) |
20Ohm |
Multiplexer/Demultiplexer Circuit |
1:1 |
Off-state Isolation-Nom |
37 dB |
Current - Leakage (IS(off)) (Max) |
100nA |
Channel Capacitance (CS(off), CD(off)) |
10pF |
On-state Resistance Match-Nom |
25Ohm |
Switch Circuit |
SPST - NO |
Channel-to-Channel Matching (ΔRon) |
10 Ω |
Switch-on Time-Max |
25ns |
Switch-off Time-Max |
35ns |
Voltage - Supply, Single (V+) |
2V~5.5V |
Normal Position |
NO |
Height Seated (Max) |
2.05mm |
Length |
10.2mm |
RoHS Status |
Non-RoHS Compliant |
Lead Free |
Contains Lead |
MC74LVXT4066M Overview
Shipping overseas is convenient due to the electrical component's packing in 14-SOIC (0.209, 5.30mm Width). The advanced packaging method Tube provides high reliability. It is mounted in the position Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. The operating temperature is extended to around -55°C~85°C TA. Totally, there are 14 terminations. A high-quality output is provided by the electrical component's 1 channels. A 3V voltage supply should turn on and run the electronic component. A key feature of the 14 series is the inclusion of this electronic part as part of its design. These analog multiplexers are built based on SPST - NO switching circuits. A total of 4 circuits make up this switch device. Look for analog switch ic variants by searching with MC74LVXT4066. In this multiplexer, the internal resistance is 30Ohm. The datasheets for the 14 pins explain the functions. It is a typical Multiplexer or Switches analog multiplexer. A voltage higher than 5.5V should not normally be supplied to the switches. Analogue multiplexers of the Single supply type that are cost-effective. In order for the electronic part to function properly, the lowest voltage should be 2V. 40μA current would be enough for this multiplexer to operate. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. Put voltage above 4μA on the multiplexer to cause damage. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. Operating voltages range from 5V.
MC74LVXT4066M Features
1 Channels
Switch Circuit: SPST - NO
40μA Supply Current
-3db Bandwidth: 160MHz
MC74LVXT4066M Applications
There are a lot of ON Semiconductor MC74LVXT4066M Analog Switches & Multiplexers ICs applications.
- Microprocessor Controlled Analog Systems
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Digital Cross-Connects
- Avionics and Military Systems
- Channelized and Unchannelized DS3 applications
- Precision test equipment
- Audio signal routing
- MP3 players
- PDAs
- Audio and video signal routing