MC74VHC4316DTR2G
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 3 days ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 16 |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2006 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 110Ohm |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 450mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Number of Functions | 4 |
| Supply Voltage | 4.5V |
| Terminal Pitch | 0.65mm |
| Base Part Number | MC74VHC4316 |
| Pin Count | 16 |
| Polarity | Non-Inverting |
| Number of Channels | 1 |
| Max Supply Voltage | 6V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 40μA |
| Power Dissipation | 450mW |
| Propagation Delay | 60 ns |
| Turn On Delay Time | 130 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Number of Inputs | 4 |
| Voltage - Supply, Single/Dual (±) | 2V~6V ±2V~6V |
| Halogen Free | Halogen Free |
| Supply Type | Dual |
| Bandwidth | 150MHz |
| Neg Supply Voltage-Nom (Vsup) | -4.5V |
| Turn-Off Delay Time | 140 ns |
| Max Dual Supply Voltage | 12V |
| -3db Bandwidth | 160MHz |
| On-State Resistance (Max) | 90Ohm |
| Min Dual Supply Voltage | 1V |
| High Level Output Current | 25mA |
| Low Level Output Current | 25mA |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 50 dB |
| Current - Leakage (IS(off)) (Max) | 100nA |
| Channel Capacitance (CS(off), CD(off)) | 10pF |
| On-state Resistance Match-Nom | 15Ohm |
| Switch Circuit | SPST - NO/NC |
| Channel-to-Channel Matching (ΔRon) | 15 Ω |
| Crosstalk | -80dB @ 1MHz |
| Height Seated (Max) | 1.2mm |
| Length | 5mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MC74VHC4316DTR2G Overview
The electrical component comes in 16-TSSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. High reliability is achieved by using advanced packaging method Tape & Reel (TR). In Surface Mount, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 1:1. Around -55°C~125°C TA is the extended operating temperature. In total, there are 16 terminations. By its 1 channels, the electronic component provides high-quality output. When a voltage supply of 4.5V is used, the electronic component should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. SPST - NO/NC switching circuits are used in these analog switch ics. Look for analog switch ic variants by searching with MC74VHC4316. It has an internal resistance of 110Ohm. The functions of 16 pins can be found in the datasheets. Theswitch device is a typical Multiplexer or Switches. In normalcircumstances, users should not exceed 6V volts for the multiplexer. Dual supply type digital switch with a low cost. A low voltage of 2V should be applied to the electronic component. For this digital switch to work, 40μA current would suffice. For this switch, a dual supply voltage is feasible, but it must not exceed 12VFor dual power supplies, a voltage of at least 1V should be attached. Operating the 4 inputs requires 4 inputs. The data can be transferred over a wide range of bandwidths, called 150MHz bandwidths.
MC74VHC4316DTR2G Features
1 Channels
Switch Circuit: SPST - NO/NC
40μA Supply Current
-3db Bandwidth: 160MHz
Bandwidth: 150MHz
MC74VHC4316DTR2G Applications
There are a lot of ON Semiconductor MC74VHC4316DTR2G Analog Switches & Multiplexers ICs applications.
- Data switching
- Mechanical reed relay replacement
- Modems
- Digital cross connects (DSX-1)
- Ultrasound
- Video signal routing
- Frame Relay Equipment
- Remote Powered Equipment
- Cell phones
- Communication systems
