banner_page

MCP1316MT-29KE/OT

3V5 Terminals MCP1316M Voltage supervisor1 Channels Min 1V Max 5.5V


  • Manufacturer: Microchip Technology
  • Nocochips NO: 536-MCP1316MT-29KE/OT
  • Package: SC-74A, SOT-753
  • Datasheet: PDF
  • Stock: 157
  • Description: 3V5 Terminals MCP1316M Voltage supervisor1 Channels Min 1V Max 5.5V (Kg)

Details

Tags

Parameters
Base Part Number MCP1316M
Output Open Drain or Open Collector
Number of Channels 1
Max Supply Voltage 5.5V
Min Supply Voltage 1V
Max Supply Current 10μA
Adjustable Threshold NO
Quiescent Current 1μA
Watchdog Timer Yes
Reset Active Low
Voltage - Threshold 2.9V
Number of Voltages Monitored 1
Reset Timeout 140ms Minimum
Min Reset Threshold Voltage 29mV
Max Reset Threshold Voltage 174mV
Height 1.3mm
Length 3.1mm
Width 1.8mm
Radiation Hardening No
RoHS Status ROHS3 Compliant
Lead Free Lead Free
Factory Lead Time 1 Week
Mount Surface Mount
Mounting Type Surface Mount
Package / Case SC-74A, SOT-753
Number of Pins 5
Operating Temperature -40°C~125°C TA
Packaging Cut Tape (CT)
Published 2005
Part Status Active
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 5
Type Simple Reset/Power-On Reset
Max Power Dissipation 240mW
Terminal Position DUAL
Terminal Form GULL WING
Number of Functions 1
Supply Voltage 3V

MCP1316MT-29KE/OT Overview


A total of 5 terminals are used to mount this power management. Packaged in the form of a Cut Tape (CT), power management is easy to use. Power management is possible to find a series of 1 functions. This power management is made up of 1 channels which are available in a series format. There are SC-74A, SOT-753 functions included in this PMIC so that you can refer to them. There are a lot of similarities between this IC power and other Simple Reset/Power-On Reset products. The supervisor is always powered by a 3V volt supply. In a 1 supply voltage, the PMIC chip conducts. Surface Mount is the one that mounts power management. Pin count of the power management is 5. It is recommended that the minimum supply voltage (Vsup) for this IC management should not be less than 1V volts. This IC power should be powered by no more than 5.5V volts of supply voltage (Vsup). The recommended mounting type for IC management is Surface Mount. This power management is the recommended temperature range for the supervisors: -40°C~125°C TA. While this power management is operating, it will output Open Drain or Open Collector as the output voltage. To find similar IC managements from the manufacturer, you can always search by MCP1316M. The maximum supply temperature is 10μA.

MCP1316MT-29KE/OT Features


Simple Reset/Power-On Reset type
Minimum supply voltage of 1V

MCP1316MT-29KE/OT Applications


There are a lot of Microchip Technology MCP1316MT-29KE/OT Voltage Supervisors applications.

  • Electronics installed in the vehicle
  • Medical-specific insulation monitor
  • Utility meter
  • Dash board
  • DC stabilized power supply module
  • Network equipment
  • Personal computers
  • Detection of phase sequence
  • Digitally controlled LDO regulators circuit
  • Cloud computing

Write a review

Note: HTML is not translated!
    Bad           Good