MCP6V14-E/ST
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 14-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 14 |
| Operating Temperature | -40°C~125°C |
| Packaging | Tube |
| Published | 2014 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 14 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Subcategory | Operational Amplifier |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 3 |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | MCP6V14 |
| Output Type | Rail-to-Rail |
| Number of Channels | 4 |
| Nominal Supply Current | 6.5μA |
| Current - Supply | 6.5μA |
| Slew Rate | 0.03V/μs |
| Amplifier Type | Zero-Drift |
| Common Mode Rejection Ratio | 119 dB |
| Current - Input Bias | 5pA |
| Voltage - Supply, Single/Dual (±) | 1.6V~5.5V |
| Input Offset Voltage (Vos) | 8μV |
| Bandwidth | 80 kHz |
| Unity Gain BW-Nom | 80 kHz |
| Power Supply Rejection Ratio (PSRR) | 118dB |
| Supply Voltage Limit-Max | 6.5V |
| Current - Output / Channel | 17mA |
| Height | 1.05mm |
| Length | 5.1mm |
| Width | 4.5mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
MCP6V14-E/ST Overview
In the package, you will find a 14-TSSOP (0.173, 4.40mm Width)-case to contain the op amp ic. Zero-Drift-type instrumentation amplifiers are used in this application. As far as the packaging is concerned, buffer op amp is delivered in a Tube case. The number of terminations is approaching the 14 mark. It should be noted that this op amp is a type of Operational Amplifier device. 14 pins are available on the instrumentation amplifier. In terms of input offset voltage, operational amplifier rates 8μV. The mounting type that is recommended for this electrical part is Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~125°C. There are a total of 4 channels available on the op amps. On the output type, there are Rail-to-Rail different types of op amps. As a result, it is recommended that a power supply of 6.5μA be used with this electronic part.
MCP6V14-E/ST Features
Output Type: Rail-to-Rail
MCP6V14-E/ST Applications
There are a lot of Microchip Technology MCP6V14-E/ST Instrumentational OP Amps applications.
- High-frequency data acquisition systems
- Multiplication circuits
- Radiation thermometry transducers
- Mobile phone
- Semiconductor detectors
- Vehicle electronics
- Comparator
- Inverse/same-phase proportional circuit
- Micro signal measurement
- Oscilloscopes
