MIC2182-5.0BM
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | no |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Terminal Finish | TIN LEAD |
| Technology | BICMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 240 |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Function | Step-Down |
| Number of Outputs | 1 |
| Qualification Status | COMMERCIAL |
| Output Voltage | 5V |
| Output Type | Transistor Driver |
| Input Voltage-Nom | 15V |
| Analog IC - Other Type | SWITCHING CONTROLLER |
| Output Configuration | Positive |
| Voltage - Supply (Vcc/Vdd) | 4.5V~32V |
| Control Features | Enable, Soft Start |
| Input Voltage (Min) | 4.5V |
| Topology | Buck |
| Control Mode | CURRENT-MODE |
| Frequency - Switching | 300kHz |
| Input Voltage (Max) | 32V |
| Control Technique | PULSE WIDTH MODULATION |
| Synchronous Rectifier | Yes |
| Switcher Configuration | PUSH-PULL |
| Duty Cycle (Max) | 86% |
| Length | 9.9mm |
| Width | 3.9mm |
| RoHS Status | Non-RoHS Compliant |
MIC2182-5.0BM Overview
With a 16-SOIC (0.154, 3.90mm Width) package, the switching controller is suitable for a wide range of applications. 1 outputs are supported by the dc motor controller. An enclosure of Tube is used to package the PMIC. A total of Transistor Driver dc switching's outputs can be handled by it. dc controls with 4.5V~32V voltage are supplied and operated. Workable in an dc switcher where -40°C~85°C TA is the -40°C~85°C TArm. The switching controller can be switched at 300kHz. The Surface Mount value makes it suitable for general dc dc regulator. For efficient switching control, the dcdc regulator features Enable, Soft Start. A SWITCHING CONTROLLER analog integrated circuit is connected to the switch converters. Switching converters are designed with the terminal (s) at position DUAL . A variety of 16 terminations are available in dc switching. These dc dc converter ics adapt several control methods, including PULSE WIDTH MODULATION. DC switcher's input voltageis set to 15V. It is recommended that the input voltage of the dc dc voltage regulator be 4.5V. According to the test statistics, DC regulator outputs 5V voltage. It should be fully noted that the dc to dc regulator only accepts 32V input voltage at most.
MIC2182-5.0BM Features
Transistor Driver Outputs
Switching Frequency: 300kHz
Enable, Soft Start
PULSE WIDTH MODULATION
MIC2182-5.0BM Applications
There are a lot of Rochester Electronics, LLC MIC2182-5.0BM DC to DC converter applications.
- Production lines
- PSRR circuits
- Various precision measuring detectors
- Communication system
- Emergency lighting monitoring equipment
- Overvoltage protection circuits in TV sets
- Digital display device
- Imported equipment
- Magnetohydrodynamic power
- CMM
