banner_page

MIC2583R-MBQS

Tube Obsolete 1 Surface Mount Hot Swap Controllers 1.5mA mA Auto Retry 16-SSOP (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller


  • Manufacturer: Rochester Electronics, LLC
  • Nocochips NO: 699-MIC2583R-MBQS
  • Package: 16-SSOP (0.154, 3.90mm Width)
  • Datasheet: PDF
  • Stock: 332
  • Description: Tube Obsolete 1 Surface Mount Hot Swap Controllers 1.5mA mA Auto Retry 16-SSOP (0.154, 3.90mm Width) 1 General Purpose Hot Swap Controller (Kg)

Details

Tags

Parameters
Mounting Type Surface Mount
Package / Case 16-SSOP (0.154, 3.90mm Width)
Surface Mount YES
Operating Temperature -40°C~85°C
Packaging Tube
JESD-609 Code e0
Feature Auto Retry
Pbfree Code no
Part Status Obsolete
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Number of Terminations 16
Type Hot Swap Controller
Terminal Finish TIN LEAD
Applications General Purpose
Additional Feature UNDERVOLTAGE LOCKOUT PROTECTION, POWER ON RESET
Voltage - Supply 2.3V~13.2V
Terminal Position DUAL
Terminal Form GULL WING
Peak Reflow Temperature (Cel) 240
Number of Functions 1
Supply Voltage 5V
Terminal Pitch 0.635mm
Time@Peak Reflow Temperature-Max (s) 30
Pin Count 16
Supply Voltage-Min (Vsup) 2.3V
Number of Channels 1
Adjustable Threshold YES
Current - Supply 1.5mA
Internal Switch(s) No
Programmable Features Fault Timeout, Slew Rate, UVLO
Feature Pins CFILTER, CPOR, DIS, /FAULT, FB, ON, /POR, PWRGD
Length 4.89mm
Width 3.9mm
RoHS Status Non-RoHS Compliant

MIC2583R-MBQS Overview


As part of the 16-SSOP (0.154, 3.90mm Width) package, it is included.Channel 1 is currently available.In the form of a Tube, it is packaged.There are a total of 16 terminations on it.This device has a terminal position of DUAL.In total, there are 16 pins on it.High efficiency can be achieved with a voltage supply of 5V.Surface Mount is set up this way.In the electrical industry, this component is categoriHot Swap Controllered as Hot Swap Controller.A temperature setting of -40°C~85°C will ensure reliable operation.There are General Purpose applications on the device.An article about it appears in Auto Retry.Hot-swappable device should work if you use a 2.3V~13.2VV power source.There are Fault Timeout, Slew Rate, UVLO features that can be programmed.Presently, there is a sufficient supply of 1.5mA.Normally, Vsup should remain above 2.3V.Using this device, UNDERVOLTAGE LOCKOUT PROTECTION, POWER ON RESET can also be produced.

MIC2583R-MBQS Features


The terminal position of 16
Features of Auto Retry
Programmable features of Fault Timeout, Slew Rate, UVLO

MIC2583R-MBQS Applications


There are a lot of Rochester Electronics, LLC MIC2583R-MBQS hot swap controllers applications.

  • Raid
  • Backplane
  • Other forms of communications infrastructure
  • Disconnect faulty loads before supply voltage drops
  • Overcurrent protection
  • Servers
  • Switch
  • Temperature monitor output
  • Comprehensive analog and digital capabilities
  • Inrush current control

Write a review

Note: HTML is not translated!
    Bad           Good