MIC706PMY
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 8 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| Published | 2006 |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Type | Simple Reset/Power-On Reset |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Additional Feature | WATCHDOG TIMER, MANUAL RESET INPUT |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | MIC706 |
| Qualification Status | Not Qualified |
| Number of Channels | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.4V |
| Nominal Supply Current | 30μA |
| Power Dissipation | 400mW |
| Adjustable Threshold | NO |
| Watchdog Timer | Yes |
| Reset | Active Low |
| Voltage - Threshold | 2.63V |
| Number of Voltages Monitored | 1 |
| Reset Timeout | 140ms Minimum |
| Min Reset Threshold Voltage | 2.55V |
| Max Reset Threshold Voltage | 2.7V |
| Length | 4.9mm |
| Width | 3.9mm |
| RoHS Status | ROHS3 Compliant |
MIC706PMY Overview
A total of 8 terminals are used to mount this power management. In terms of packaging, power management follows the Tube model. There are 1 functions included in this PMIC so that you can refer to them. Power management consists of 2 channels, each of which can be used independently. In this PMIC, you can find 8-SOIC (0.154, 3.90mm Width) functions for your reference. There are a lot of similarities between this IC power and other Simple Reset/Power-On Reset products. IC management is specified that the package peak reflow temperature should be 260. IC management conducts at a voltage of 5V. When a supply voltage of 1 is applied to the power ic, it conducts. Power management is included in the Surface Mount mount. The pins of the power management system count 8. Supply voltage (Vsup) should be at least 1.4V for this power management. This IC power should be powered by no more than 5.5V volts of supply voltage (Vsup). The mounting type of the supervisors is Surface MountThe temperature of the supervisors should be set to this range: -40°C~85°C TA. There are other features such as WATCHDOG TIMER, MANUAL RESET INPUT to name a few. It is always advisable to use MIC706, the base supervisor number, when searching for similar PMICs from the manufacturer.
MIC706PMY Features
Simple Reset/Power-On Reset type
Minimum supply voltage of 1.4V
MIC706PMY Applications
There are a lot of Microchip Technology MIC706PMY Voltage Supervisors applications.
- Efficient information transmission
- Insulation fault location system
- Stable power system
- Digitally controlled LDO regulators circuit
- Power distribution systems of ICU
- Computer applications
- Important electronics for automotive safety
- DVR
- Automotive permanent magnet synchronous motors
- Refrigeration
