banner_page

MM74HC4316MTC

14ns, 20ns SPST - NO 70Ohm Analog Switches 74HC4316 100nA 16-TSSOP (0.173, 4.40mm Width)


  • Manufacturer: ON Semiconductor
  • Nocochips NO: 598-MM74HC4316MTC
  • Package: 16-TSSOP (0.173, 4.40mm Width)
  • Datasheet: PDF
  • Stock: 628
  • Description: 14ns, 20ns SPST - NO 70Ohm Analog Switches 74HC4316 100nA 16-TSSOP (0.173, 4.40mm Width)(Kg)

Details

Tags

Parameters
Mount Surface Mount
Mounting Type Surface Mount
Package / Case 16-TSSOP (0.173, 4.40mm Width)
Number of Pins 16
Operating Temperature -40°C~85°C TA
Packaging Tube
Part Status Obsolete
Moisture Sensitivity Level (MSL) 1 (Unlimited)
Resistance 70Ohm
Max Power Dissipation 500mW
Base Part Number 74HC4316
Max Supply Voltage 6V
Min Supply Voltage 2V
Power Dissipation 500mW
Max Supply Current 2μA
Throw Configuration SPST
Turn On Delay Time 205 ns
Number of Inputs 4
Voltage - Supply, Single/Dual (±) 2V~12V ±2V~6V
Supply Type Dual, Single
Turn-Off Delay Time 265 ns
Max Dual Supply Voltage 6V
-3db Bandwidth 100MHz
On-State Resistance (Max) 70Ohm
Min Dual Supply Voltage 1V
Multiplexer/Demultiplexer Circuit 1:1
Current - Leakage (IS(off)) (Max) 100nA
Switch Circuit SPST - NO
Switch Time (Ton, Toff) (Max) 14ns, 20ns
Channel-to-Channel Matching (ΔRon) 5 Ω
Crosstalk -50dB @ 1MHz
RoHS Status RoHS Compliant
Lead Free Lead Free

MM74HC4316MTC Overview


Shipping overseas is convenient due to the electrical component's packing in 16-TSSOP (0.173, 4.40mm Width). To ensure high reliability, a new packaging method Tube is used. There is an analog multiplexer mounted in position Surface Mount. There is 1:1 ratio between the number of multiplexers and demultiplexers. Operating temperature extended to -40°C~85°C TA. These analog multiplexers are built based on SPST - NO switching circuits. Using the 74HC4316 search parameter, you can discover variants of the switch. An switch multiplexer with 70Ohm internal resistance has a value of 70Ohm. The functions of 16 pins can be found in the datasheets. It is normally recommended that users do not supply the multiplexer with voltages higher than 6V. A analog switch ic that has a cost-effective Dual, Single supply type. There should be 2V voltage fed to the electrical part below 2V. A digital multiplexer may suffer damage if voltage is applied above 2μA. For this multiplexer, dual supply voltage is feasible, but it should not exceed 6V. If you are using a dual power supply, you should attach at least 1V. It is possible to operate 4 inputs.

MM74HC4316MTC Features


Switch Circuit: SPST - NO
-3db Bandwidth: 100MHz

MM74HC4316MTC Applications


There are a lot of ON Semiconductor MM74HC4316MTC Analog Switches & Multiplexers ICs applications.

  • Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
  • Remote wireless modules
  • T1/E1 Terminals
  • Avionics
  • RGB switches
  • Signal routing between systems
  • Existing multiplexer applications (both fault-protected and nonfault-protected)
  • Automotive applications
  • Communication systems
  • High speed data transmission line cards

Write a review

Note: HTML is not translated!
    Bad           Good