MP2735DQG-LF-Z
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 10-VFQFN |
| Number of Pins | 10 |
| Weight | 7.002332mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| JESD-609 Code | e3 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Resistance | 450mOhm |
| Terminal Finish | Matte Tin (Sn) |
| Max Power Dissipation | 208mW |
| Peak Reflow Temperature (Cel) | 260 |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Operating Supply Voltage | 3V |
| Number of Circuits | 2 |
| Max Supply Voltage | 3.3V |
| Min Supply Voltage | 2.7V |
| Max Supply Current | 1μA |
| Turn On Delay Time | 36 ns |
| Supply Type | Single |
| Turn-Off Delay Time | 30 ns |
| -3db Bandwidth | 50MHz |
| On-State Resistance (Max) | 450mOhm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Current - Leakage (IS(off)) (Max) | 40nA |
| Channel Capacitance (CS(off), CD(off)) | 55pF |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 36ns, 30ns |
| Channel-to-Channel Matching (ΔRon) | 10m Ω |
| Crosstalk | -70dB @ 100kHz |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MP2735DQG-LF-Z Overview
Shipping overseas is convenient with the electronic component packed in 10-VFQFN. The advanced packaging method Tape & Reel (TR) provides high reliability. There is an analog multiplexer mounted in position Surface Mount. Multiplexer and demultiplexer circuits have a number 2:1. Operation at a temperature around -40°C~85°C TA. On the other hand, analog switches can be constructed using SPDT switching circuits. A total of 2 circuits make up this switch device. As far as internal resistance is concerned, it has 450mOhm. To find out what the functions of 10 pins are, please refer to their datasheets. In a normalsituation, users should not supply the switches with voltage higher than 3.3V. The digital multiplexer has a low cost Single supply. A low voltage of 2.7V should be applied to the electronic component. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. Putting voltage greater than 1μA on the multiplexer may cause damage. 3V operating voltages are supported by the electronic component.
MP2735DQG-LF-Z Features
Switch Circuit: SPDT
-3db Bandwidth: 50MHz
MP2735DQG-LF-Z Applications
There are a lot of Monolithic Power Systems Inc. MP2735DQG-LF-Z Analog Switches & Multiplexers ICs applications.
- Microwave transmission systems
- FTTH
- RGB switches
- Wireless Local Loop
- Switching Systems
- Audio and video signal routing
- Access Concentrators
- Sample-and-hold systems
- Industrial
- High speed data transmission line cards
