MP5010SDQ-LF-Z
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 10-VFDFN Exposed Pad |
| Number of Pins | 10 |
| Operating Temperature | -40°C~125°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2012 |
| JESD-609 Code | e3 |
| Feature | Slew Rate Controlled, Status Flag |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 10 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 5A |
| Supply Voltage-Min (Vsup) | 4V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Switch Type | General Purpose |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 4V~18V |
| Fault Protection | Current Limiting (Adjustable), Over Temperature, Over Voltage, UVLO |
| Rds On (Typ) | 40m Ω |
| Built-in Protections | TRANSIENT; OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 3mm |
| Width | 3mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
MP5010SDQ-LF-Z Overview
The LED driver's packaged as a Tape & Reel (TR).There is a package for it in the 10-VFDFN Exposed Pad package.Surface Mount is the mounting type of the LED driver.There is a General Purpose switch type associated with it.It is recommended that the temperature be set to -40°C~125°C TJ for reliable operation.The lighting driver has a total of 1 outputs that are available for use.In order to operate, it requires a voltage supply of Not Required.A maximum output voltage of N-Channel volts can be obtained with this LED driver.As far as features are concerned, the LED driving board has Slew Rate Controlled, Status Flag.As a result, there are 10 terminations.In order to operate, 10 pins are used.Currently, there are 1 functions associated with the lighting driver.Maximum output current falls to 5A when operation criteria are met.Using a voltage of 5V allows for high efficiency.The LED driving board is mounted in the way of Surface Mount.In order to operate normally, the supply voltage (Vsup) must remain above 4V.
MP5010SDQ-LF-Z Features
Supplied from 5V
MP5010SDQ-LF-Z Applications
There are a lot of Monolithic Power Systems Inc. MP5010SDQ-LF-Z Power Switches ICs applications.
- Portable/Handheld Devices
- Portable Devices
- Gaming
- Smartphone and PDA
- Storage (HDDs, SSDs)
- Smart Phones, Feature Phones
- Notebook and Tablet Computers
- Telecom and Network Systems
- PC Card Hot Swap
- Mobile Communication Devices
