NCS199A1SQT2G
| Parameters | |
|---|---|
| Common Mode Rejection Ratio | 115 dB |
| Current - Input Bias | 60μA |
| Voltage - Supply, Single/Dual (±) | 2.7V~26V |
| Input Offset Voltage (Vos) | 5μV |
| Bandwidth | 100 kHz |
| Length | 2mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-TSSOP, SC-88, SOT-363 |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C |
| Packaging | Cut Tape (CT) |
| Published | 2012 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Terminal Finish | Tin (Sn) |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Output Type | Rail-to-Rail |
| Supply Voltage-Min (Vsup) | 2.7V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 65μA |
| Adjustable Threshold | NO |
| Slew Rate | 0.4V/μs |
| Amplifier Type | Current Sense |
NCS199A1SQT2G Overview
There is a 6-TSSOP, SC-88, SOT-363 case in which the instrumentation amplifier is packaged. There are two types of operational amplifiers in this circuit. The op amp is delivered to you in a Cut Tape (CT) case. The number of terminations approaches 6. It would be helpful if you could remember that this op amp ic should be powered by an 3.3V battery. The op amp ic has an array of 6 pins on it. With regards to the offset voltage of the input, buffer amplifier is rated at 5μV. This electronic part is best mounted with type Surface Mount. In terms of operating temperature, this instrumentation amplifier is well suited to a temperature range of -40°C~125°C. A supply current of 65μA can be used to operate this linear amplifier. This op amp contains 1 circuits. The op amp ic has 1 channels on it. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. An analog IC that is also used in this instrumentation amplifier is referred to as the POWER SUPPLY SUPPORT CIRCUIT type.
NCS199A1SQT2G Features
supply voltage of 3.3V
Output Type: Rail-to-Rail
NCS199A1SQT2G Applications
There are a lot of ON Semiconductor NCS199A1SQT2G Instrumentational OP Amps applications.
- High input resistance broadband
- Switching amplifier
- Micro signal measurement
- Radar
- Video computer boards
- Image computer boards
- Automation control systems
- single/dual op amp sum and difference circuits
- Signal operation
- Video conversion and routing
