NCS199A2SQT2G
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-TSSOP, SC-88, SOT-363 |
| Number of Pins | 6 |
| Operating Temperature | -40°C~125°C |
| Packaging | Cut Tape (CT) |
| Published | 2012 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| Terminal Finish | Tin (Sn) |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Number of Functions | 1 |
| Supply Voltage | 3.3V |
| Output Type | Rail-to-Rail |
| Supply Voltage-Min (Vsup) | 2.7V |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Analog IC - Other Type | POWER SUPPLY SUPPORT CIRCUIT |
| Operating Supply Current | 65μA |
| Adjustable Threshold | NO |
| Slew Rate | 0.4V/μs |
| Amplifier Type | Current Sense |
| Common Mode Rejection Ratio | 120 dB |
| Current - Input Bias | 60μA |
| Voltage - Supply, Single/Dual (±) | 2.7V~26V |
| Input Offset Voltage (Vos) | 5μV |
| Bandwidth | 60 kHz |
| Length | 2mm |
| REACH SVHC | No SVHC |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
NCS199A2SQT2G Overview
Op amp is packaged in 6-TSSOP, SC-88, SOT-363 case. Buffer amps of this type are called Current Sense-types. The case in which buffer amplifier is delivered is called a Cut Tape (CT) case. There have been a total of 6 terminations over the past year. I would like to remind you that this buffer op amp should be powered by an 3.3V battery. An 6-pin op amp ic is included in the package. In terms of input offset voltage, operational amplifier rates 5μV. For this electrical component, Surface Mount is the recommended mounting type. It is important to note that this linear amplifier works well at a temperature of -40°C~125°C when it comes to operating temperatureThe buffer amplifier is capable of operating from a supply current of 65μA . This op amp ic has 1 circuits. There are 1 channels on the operational amplifiers. There are more than a few advantages to using this instrumentation amplifier, one of which is that it outputs Rail-to-Rail signals. The buffer op amp also uses a POWER SUPPLY SUPPORT CIRCUIT analog IC.
NCS199A2SQT2G Features
supply voltage of 3.3V
Output Type: Rail-to-Rail
NCS199A2SQT2G Applications
There are a lot of ON Semiconductor NCS199A2SQT2G Instrumentational OP Amps applications.
- Portable docking station
- Active probe
- MP3
- Wireless base stations
- Portable media players
- Portable electronic products powered by batteries
- Switching amplifier
- Computer workstations
- Micro signal measurement
- Mobile phone
