Parameters |
Factory Lead Time |
1 Week |
Lifecycle Status |
ACTIVE (Last Updated: 22 hours ago) |
Mount |
Surface Mount |
Mounting Type |
Surface Mount |
Package / Case |
14-TSSOP (0.173, 4.40mm Width) |
Operating Temperature |
-40°C~125°C |
Packaging |
Tape & Reel (TR) |
Published |
2006 |
JESD-609 Code |
e4 |
Pbfree Code |
yes |
Part Status |
Active |
Moisture Sensitivity Level (MSL) |
1 (Unlimited) |
Number of Terminations |
14 |
ECCN Code |
EAR99 |
Terminal Finish |
Nickel/Palladium/Gold (Ni/Pd/Au) |
Subcategory |
Operational Amplifier |
Technology |
CMOS |
Terminal Position |
DUAL |
Terminal Form |
GULL WING |
Peak Reflow Temperature (Cel) |
NOT SPECIFIED |
Number of Functions |
4 |
Supply Voltage |
5V |
Terminal Pitch |
0.65mm |
Time@Peak Reflow Temperature-Max (s) |
NOT SPECIFIED |
Output Type |
Rail-to-Rail |
Number of Circuits |
4 |
Operating Supply Current |
465μA |
Slew Rate |
2.4V/μs |
Amplifier Type |
General Purpose |
Common Mode Rejection Ratio |
125 dB |
Current - Input Bias |
1.5nA |
Voltage - Supply, Single/Dual (±) |
2.7V~36V ±1.35V~18V |
Input Offset Voltage (Vos) |
1.3mV |
Bandwidth |
3MHz |
Gain Bandwidth Product |
3.2MHz |
Unity Gain BW-Nom |
3200 kHz |
Average Bias Current-Max (IIB) |
0.0015μA |
Current - Output / Channel |
65mA |
Height Seated (Max) |
1.2mm |
Length |
5mm |
RoHS Status |
ROHS3 Compliant |
Lead Free |
Lead Free |
NCS20074DTBR2G Overview
There is a 14-TSSOP (0.173, 4.40mm Width) case in which the instrumentation amplifier is packaged. This is a General Purpose type op amp. As far as the packaging is concerned, buffer op amp is delivered in a Tape & Reel (TR) case. The number of terminations is approaching the 14 mark. I would like to remind you that this buffer op amp should be powered by an 5V battery. It should be noted that this op amp is a type of Operational Amplifier device. In terms of input offset voltage, operational amplifier rates 1.3mV. It is recommended that this electronic component be mounted using the Surface Mount mounting type. According to the manufacturer, this buffer op amp works well at -40°C~125°C , which is a good operating temperature. A supply current of 465μA can be used to operate this linear amplifier. In total, there are 4 circuits on this buffer amplifier. One of its many advantages is that buffer op amp outputs Rail-to-Rail signals.
NCS20074DTBR2G Features
supply voltage of 5V
Output Type: Rail-to-Rail
NCS20074DTBR2G Applications
There are a lot of ON Semiconductor NCS20074DTBR2G Instrumentational OP Amps applications.
- Blood pressure sensors
- Test and measurement instruments
- Industrial applications including automation
- High/low-pass filter circuit
- Signal amplification
- Laptop
- Vehicle electronics
- Strain gauges
- Navigation
- Logarithmic operation circuits