NLAS324USG
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 1 day ago) |
| Mounting Type | Surface Mount |
| Package / Case | 8-VFSOP (0.091, 2.30mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2006 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| Resistance | 30Ohm |
| Terminal Finish | Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 250mW |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.5mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | NLAS324 |
| Output | SEPARATE OUTPUT |
| Pin Count | 8 |
| Operating Supply Voltage | 3V |
| Number of Channels | 2 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Power Dissipation | 250mW |
| Max Supply Current | 1μA |
| Throw Configuration | SPST |
| Turn On Delay Time | 14 ns |
| Halogen Free | Halogen Free |
| Supply Type | Single |
| Turn-Off Delay Time | 22 ns |
| -3db Bandwidth | 220MHz |
| On-State Resistance (Max) | 25Ohm |
| Multiplexer/Demultiplexer Circuit | 1:1 |
| Off-state Isolation-Nom | 93 dB |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 10pF 10pF |
| Switch Circuit | SPST - NC |
| Switch Time (Ton, Toff) (Max) | 9ns, 10ns |
| Charge Injection | 3pC |
| Switching | MAKE-BEFORE-BREAK |
| Switch-off Time-Max | 16ns |
| Voltage - Supply, Single (V+) | 2V~5.5V |
| Normal Position | NC |
| Height | 800μm |
| Length | 2.4mm |
| Width | 2.1mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
NLAS324USG Overview
The electrical component comes in 8-VFSOP (0.091, 2.30mm Width) packaging, which makes it convenient to ship overseas. High reliability is provided by advanced packaging method Tape & Reel (TR). This analog switch is mounted in Surface Mount. Multiplexers and demultiplexers have a number of circuits 1:1. Operational temperature extended around -55°C~125°C TA. Total terminations are 8. A electrical component with 2 channels is capable of high-quality output. A 3V voltage supply should turn on and run the electronic component. A total of 8 pins are injected into the electrical part body. These analog multiplexers are built based on SPST - NC switching circuits. Use NLAS324 to search for variants of the digital switches. The internal resistance of this digital multiplexer is 30Ohm. Datasheets for functions of 8 pins are available. The analog multiplexer shown here is a typical Multiplexer or Switches. Multiplexers should not be powered above 5.5V in normal situations. Analogue multiplexers of the Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 2V. The switch device would be able to operate with 1μA current. An analogue multiplexer drains from a single voltage supply at 2V~5.5V. If you put voltage higher than 1μA on the digital multiplexer, damage may occur. In this switch multiplexer, there are SEPARATE OUTPUT outputs available. 3V operating voltages can be used with this electrical part.
NLAS324USG Features
2 Channels
Switch Circuit: SPST - NC
1μA Supply Current
-3db Bandwidth: 220MHz
NLAS324USG Applications
There are a lot of ON Semiconductor NLAS324USG Analog Switches & Multiplexers ICs applications.
- Relay replacements
- Audio and video signal routing
- Precision instrumentation
- FTTH
- PDAs
- Power routing
- Audio signal routing
- SONET
- Automatic test equipment
- Existing multiplexer applications (both fault-protected and nonfault-protected)
