NLAST4051DTR2
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | OBSOLETE (Last Updated: 1 day ago) |
| Mounting Type | Surface Mount |
| Package / Case | 16-TSSOP (0.173, 4.40mm Width) |
| Surface Mount | YES |
| Number of Pins | 16 |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tape & Reel (TR) |
| Published | 2006 |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| Resistance | 33Ohm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Additional Feature | ALSO OPERATES WITH 2.5V TO 6.6V (VCC-VEE) SUPPLY |
| Subcategory | Multiplexer or Switches |
| Max Power Dissipation | 450mW |
| Technology | CMOS |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 3V |
| Terminal Pitch | 0.65mm |
| Time@Peak Reflow Temperature-Max (s) | 40 |
| Base Part Number | NLAST4051 |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Supply Voltage | 5.5V |
| Polarity | Non-Inverting |
| Power Supplies | -3.3/GND3.3/5V |
| Number of Channels | 8 |
| Number of Circuits | 1 |
| Analog IC - Other Type | SINGLE-ENDED MULTIPLEXER |
| Operating Supply Current | 40μA |
| Propagation Delay | 40 ns |
| Turn On Delay Time | 40 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Voltage - Supply, Single/Dual (±) | 3V~5V ±3V |
| Supply Type | Dual, Single |
| Bandwidth | 95MHz |
| Supply Current-Max (Isup) | 0.08mA |
| Neg Supply Voltage-Nom (Vsup) | -3V |
| Turn-Off Delay Time | 40 ns |
| On-State Resistance (Max) | 26Ohm |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 93 dB |
| Current - Leakage (IS(off)) (Max) | 100pA |
| Channel Capacitance (CS(off), CD(off)) | 10pF 10pF |
| On-state Resistance Match-Nom | 15Ohm |
| Switch Time (Ton, Toff) (Max) | 23ns, 23ns |
| Charge Injection | 12pC |
| Channel-to-Channel Matching (ΔRon) | 10 Ω |
| Switch-on Time-Max | 28ns |
| Switch-off Time-Max | 28ns |
| Signal Current-Max | 0.05A |
| Length | 5mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Lead Free |
NLAST4051DTR2 Overview
The electronic part can be shipped overseas conveniently because it is packaged in 16-TSSOP (0.173, 4.40mm Width). A high level of reliability can be achieved through the use of an advanced packaging method Tape & Reel (TR). Surface Mount is where this multiplexer is located. Multiplexers and demultiplexers have the same number of circuits 8:1. Operating temperature around -55°C~125°C TA extended. 16 terminations have been made so far. By its 8 channels, the electronic component provides high-quality output. Turning on and running the electrical part should be easy with a 3V voltage supply. A key feature of the 16 series is the inclusion of this electronic part as part of its design. Circuits number 1 make up this analogue multiplexer. Try searching with NLAST4051 if you're looking for variants. The internal resistance of this digital multiplexer is 33Ohm. The datasheets for the 16 pins explain the functions. This switch device is a typical Multiplexer or Switches. Dual, Single supply type digital switch with a low cost. For this digital switch to work, 40μA current would suffice. An analog IC with the number SINGLE-ENDED MULTIPLEXER is integrated into this board. The electrical part can be operated at 5.5V voltage levels. It is possible to transfer data over a 95MHz-bandwidth. Additional features include: ALSO OPERATES WITH 2.5V TO 6.6V (VCC-VEE) SUPPLY.
NLAST4051DTR2 Features
8 Channels
40μA Supply Current
Bandwidth: 95MHz
Additional Features: ALSO OPERATES WITH 2.5V TO 6.6V (VCC-VEE) SUPPLY
NLAST4051DTR2 Applications
There are a lot of ON Semiconductor NLAST4051DTR2 Analog Switches & Multiplexers ICs applications.
- Automatic test equipment
- RGB switches
- Industrial control systems
- ATM
- Access Concentrators
- MP3 players
- CSU
- Frame Relay Equipment
- Remote Powered Equipment
- Precision instrumentation
