NLAST44599MN
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | 16-VFQFN Exposed Pad |
| Surface Mount | YES |
| Operating Temperature | -55°C~125°C TA |
| Packaging | Tube |
| JESD-609 Code | e0 |
| Pbfree Code | yes |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 16 |
| Terminal Finish | TIN LEAD |
| Technology | CMOS |
| Terminal Position | QUAD |
| Terminal Form | NO LEAD |
| Peak Reflow Temperature (Cel) | 240 |
| Number of Functions | 2 |
| Supply Voltage | 2.5V |
| Terminal Pitch | 0.5mm |
| Reach Compliance Code | unknown |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Pin Count | 16 |
| JESD-30 Code | S-XQCC-N16 |
| Qualification Status | COMMERCIAL |
| Supply Voltage-Max (Vsup) | 5.5V |
| Number of Channels | 2 |
| Number of Circuits | 2 |
| -3db Bandwidth | 175MHz |
| On-State Resistance (Max) | 25Ohm |
| Multiplexer/Demultiplexer Circuit | 2:2 |
| Off-state Isolation-Nom | 93 dB |
| Current - Leakage (IS(off)) (Max) | 1nA |
| Channel Capacitance (CS(off), CD(off)) | 10pF 10pF |
| Switch Circuit | DPDT |
| Switch Time (Ton, Toff) (Max) | 14ns, 5ns |
| Charge Injection | 3pC |
| Crosstalk | -90dB @ 100kHz |
| Switch-on Time-Max | 35ns |
| Voltage - Supply, Single (V+) | 2V~5.5V |
| Height Seated (Max) | 1mm |
| Length | 3mm |
| RoHS Status | Non-RoHS Compliant |
NLAST44599MN Overview
Shipping overseas is convenient due to the electrical component's packing in 16-VFQFN Exposed Pad. This packaging method provides high reliability because it uses advanced packaging techniques. A switch device like this is mounted in Surface Mount. There is 2:2 ratio between the number of multiplexers and demultiplexers. Operation at a temperature around -55°C~125°C TA. In total, there are 16 terminations. By its 2 channels, the electronic component provides high-quality output. When the electronic component is given a voltage of 2.5V, it should be turned on and run. As part of its design, the 16 series is equipped with this electronic component. Based on DPDT switching circuits, these analog multiplexers work. It consists of 2 circuits. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply.
NLAST44599MN Features
2 Channels
Switch Circuit: DPDT
-3db Bandwidth: 175MHz
NLAST44599MN Applications
There are a lot of Rochester Electronics, LLC NLAST44599MN Analog Switches & Multiplexers ICs applications.
- Cable Modem
- Microprocessor Controlled Analog Systems
- ISDN NT1/TA
- Digital access cross connects
- Cable Telephony – NIU, Set-Top Box, Home Side Box
- FTTH
- Intelligent PBX
- Existing multiplexer applications (both fault-protected and nonfault-protected)
- Industrial
- T1/E1 Terminals
