NX5P2090UKZ
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 9-UFBGA, WLCSP |
| Surface Mount | YES |
| Operating Temperature | -40°C~125°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2010 |
| Series | NX5 |
| Feature | Slew Rate Controlled |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 9 |
| Subcategory | Peripheral Drivers |
| Terminal Position | BOTTOM |
| Terminal Form | BALL |
| Supply Voltage | 5V |
| Terminal Pitch | 0.4mm |
| Base Part Number | NX5P2090 |
| Pin Count | 9 |
| JESD-30 Code | S-PBGA-B9 |
| Number of Outputs | 1 |
| Qualification Status | Not Qualified |
| Output Type | N-Channel |
| Supply Voltage-Max (Vsup) | 5.5V |
| Power Supplies | 5V |
| Supply Voltage-Min (Vsup) | 4V |
| Interface | On/Off |
| Current - Output (Max) | 2A |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 3V~5.5V |
| Driver Number of Bits | 1 |
| Fault Protection | Current Limiting (Adjustable), Over Temperature, Reverse Current, UVLO |
| Rds On (Typ) | 60m Ω |
| Built-in Protections | OVER CURRENT; OVER VOLTAGE; THERMAL; UNDER VOLTAGE |
| Height Seated (Max) | 0.55mm |
| RoHS Status | ROHS3 Compliant |
NX5P2090UKZ Overview
The LED driver's packaged as a Tape & Reel (TR).It is included with the 9-UFBGA, WLCSP package as well.It has been mounted as Surface Mount on the LED driver.It owns the USB Switch switch type.Keeping the temperature at -40°C~125°C TJ ensures reliable operation.The LED driver is equipped with 1 outputs.The LED driving board operates with a supply voltage of Not Required.A maximum output voltage of N-Channel volts can be achieved by this LED driver.A lighting driver with Slew Rate Controlled features is available.As you can see, it comes from the NX5P2090 family.In total, there are 9 terminations.In this case, the LED driving board can produce only 2AV as its maximum output.With a supply voltage of 5V, high efficiency is possible.A total of 9 pins are present on it.Electrical components such as this are included in the NX5 series.The LED driver is packaged in an econtainer with a capacity of Peripheral Drivers.A maximum supply voltage of 5.5V is set in Vsup.In order for this lighting driver to operate normally, the supply voltage (Vsup) should remain above 4V.A 5V power supply is used by the part.
NX5P2090UKZ Features
Supplied from 5V
NX5P2090UKZ Applications
There are a lot of NXP USA Inc. NX5P2090UKZ Power Switches ICs applications.
- PDAs
- Storage Drives
- Hot Swap
- USB Power Distribution
- Portable GPS Device
- Handheld Devices
- Solid-State Drives
- Portable/Handheld Devices
- Wearable Devices
- Hot Swaps
