OP07DP
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 5 days ago) |
| Contact Plating | Gold |
| Mounting Type | Through Hole |
| Package / Case | 8-DIP (0.300, 7.62mm) |
| Surface Mount | NO |
| Number of Pins | 8 |
| Operating Temperature | 0°C~70°C |
| Packaging | Tube |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Subcategory | Operational Amplifier |
| Technology | BIPOLAR |
| Terminal Position | DUAL |
| Number of Functions | 1 |
| Supply Voltage | 15V |
| Terminal Pitch | 2.54mm |
| Base Part Number | OP07 |
| Pin Count | 8 |
| Number of Channels | 1 |
| Operating Supply Current | 2mA |
| Nominal Supply Current | 5mA |
| Power Dissipation | 4mW |
| Slew Rate | 0.3V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | General Purpose |
| Common Mode Rejection Ratio | 94 dB |
| Current - Input Bias | 2nA |
| Voltage - Supply, Single/Dual (±) | ±3V~18V |
| Input Offset Voltage (Vos) | 150μV |
| Bandwidth | 600 kHz |
| Neg Supply Voltage-Nom (Vsup) | -15V |
| Unity Gain BW-Nom | 600 kHz |
| Voltage Gain | 112.04dB |
| Low-Offset | YES |
| Frequency Compensation | YES |
| Supply Voltage Limit-Max | 22V |
| Voltage - Input Offset | 60μV |
| Low-Bias | NO |
| Micropower | NO |
| Programmable Power | NO |
| Dual Supply Voltage | 9V |
| Neg Supply Voltage-Max (Vsup) | -22V |
| Nominal Gain Bandwidth Product | 600 kHz |
| Max I/O Voltage | 150μV |
| Input Offset Current-Max (IIO) | 0.006μA |
| Height | 5.08mm |
| Length | 9.81mm |
| Width | 6.35mm |
| Thickness | 3.9mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
OP07DP Description
OP07DP amplifier provides low offset and long-term stability using a low-noise, chopperless, bipolar-input-transistor amplifier circuit. OP07DP op amp is powered by one power supply that operates over a variety of voltages. OP07DP circuit operation of a split power supply is also possible, and the current drain of the power supply is not dependent on the strength of the voltage at which power supplies are supplied.
OP07DP Features
Low Noise
Wide Input-Voltage Range
No External Components Required
Replace Chopper Amplifiers at a Lower Cost
Wide Supply-Voltage Range
OP07DP Applications
Switch high current loads
Speed control of Motors
High amplification
Power switches
Inverter and rectifier circuits
