OP2177ARZ-REEL7
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | PRODUCTION (Last Updated: 1 week ago) |
| Mounting Type | Surface Mount |
| Package / Case | 8-SOIC (0.154, 3.90mm Width) |
| Surface Mount | YES |
| Number of Pins | 8 |
| Operating Temperature | -40°C~125°C |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e3 |
| Pbfree Code | no |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 8 |
| ECCN Code | EAR99 |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Operational Amplifier |
| Packing Method | TAPE AND REEL |
| Technology | BIPOLAR |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 5V |
| Time@Peak Reflow Temperature-Max (s) | 30 |
| Base Part Number | OP2177 |
| Pin Count | 8 |
| Number of Channels | 2 |
| Operating Supply Current | 1mA |
| Nominal Supply Current | 400μA |
| Output Current | 10mA |
| Quiescent Current | 500μA |
| Slew Rate | 0.7V/μs |
| Architecture | VOLTAGE-FEEDBACK |
| Amplifier Type | General Purpose |
| Common Mode Rejection Ratio | 125 dB |
| Current - Input Bias | 500pA |
| Max Input Voltage | 15V |
| Voltage - Supply, Single/Dual (±) | 5V~36V ±2.5V~18V |
| Output Current per Channel | 10mA |
| Supply Type | Dual |
| Input Offset Voltage (Vos) | 75μV |
| Gain Bandwidth Product | 1.3MHz |
| Neg Supply Voltage-Nom (Vsup) | -5V |
| Unity Gain BW-Nom | 1300 kHz |
| Voltage Gain | 126.02dB |
| Power Supply Rejection Ratio (PSRR) | 125dB |
| Low-Offset | YES |
| Frequency Compensation | YES |
| Voltage - Input Offset | 15μV |
| Low-Bias | NO |
| Micropower | YES |
| Programmable Power | NO |
| Wideband | NO |
| Height Seated (Max) | 1.75mm |
| Length | 4.9mm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Contains Lead |
OP2177ARZ-REEL7 Overview
Packaged in a 8-SOIC (0.154, 3.90mm Width) case, the buffer op amp is ready to use. An op amp ic of the General Purpose type. Upon delivery, op amp ic is packaged in a Tape & Reel (TR) case. During the past two weeks, there have been close to 8 terminations. The total number of pins on linear amplifier is 8. The linear amplifier should be run at 5V at all times, so please keep that in mind when using it. To be specific, this instrumentation amplifier is a type of Operational Amplifier. 8 pins are located on the operational amplifiers. Regarding input offset voltage, buffer amplifier rates 75μV voltage. For this electrical component, Surface Mount is the recommended mounting type. It is important to note that this linear amplifier works well at a temperature of -40°C~125°C when it comes to operating temperatureAn 1mA volt supply current is needed for this linear amplifier to operate. You should keep the voltage gain at 126.02dB for the time being. The op amp ic has 2 channels on it. As a result of this, the buffer amplifier is packed in TAPE AND REEL. 500μA quiescent currents are flowing through buffer op amp.
OP2177ARZ-REEL7 Features
8 Pins
supply voltage of 5V
126.02dB voltage gain
OP2177ARZ-REEL7 Applications
There are a lot of Analog Devices Inc. OP2177ARZ-REEL7 Instrumentational OP Amps applications.
- Band-stop filter
- Inverse/same-phase proportional circuit
- Polarized electrodes
- Integrator circuits
- Proportional counter tubes
- Radiation thermometry transducers
- High input resistance broadband
- Television broadcasting equipment
- Cinema or auditorium audio system
- Commercial audio systems
