QS3245QG8
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | QSOP |
| Number of Pins | 20 |
| Published | 2011 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Resistance | 15Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Bus Driver/Transceivers |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.635mm |
| Pin Count | 20 |
| Operating Supply Voltage | 5V |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Power Dissipation-Max | 500mW |
| Number of Ports | 2 |
| Nominal Supply Current | 3μA |
| Number of Bits | 8 |
| Propagation Delay | 250 ps |
| Quiescent Current | 3μA |
| Turn On Delay Time | 5.6 ns |
| Family | 3245 |
| Output Characteristics | 3-STATE |
| Supply Type | Single |
| Output Polarity | TRUE |
| Logic IC Type | BUS DRIVER |
| High Level Output Current | -120mA |
| Low Level Output Current | 120mA |
| Independent Circuits | 1 |
| Length | 8.7mm |
| Width | 3.8mm |
| Thickness | 1.47mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
QS3245QG8 Overview
In order to conserve board space, digital switch is included in the QSOP.Among its basic configurations are 20 terminations.The multiplexer's system works with 5V voltage.This turn signal switch consists of 20 component pins.As a result, GULL WING represents the end of the conductors.In this case, the supply type is Single.A configuration of 20 pins is used.It is mounted in the way of Surface Mount.I would like to refer to the logic switch as a member of the 3245 family.Signal multiplexer provides 8 bits.During mux switch's normal operation, 5V is provided with a power supply.The digital switch ic is an electronic part classified into Bus Driver/Transceivers.It consumes 3μA current of multiplexer ic since it is not affected by external factors.Reliable performance of the multiplexers can be achieved when a supply voltage of 5V is provided.The resistance is 2.With a resistance of 15Ohm, it operates.The maximum operating temperature of 85°C is acceptable for this signal switch.Ideally, the temperature of the multiplexer should not exceed -40°C.It is specified that the signal switches should operate at 5.25V as its maximum supply voltage.The digital swith is specified to operate at the minimum supply voltage of 4.75V in compliance with the applicable device specification.The logic IC of the digitalswitch is BUS DRIVER.
QS3245QG8 Features
Supplied in the QSOP package
Adopting a supply type of Single
Power supplies of 5V
Operating with the supply voltage of 5V
BUS DRIVER as the logic IC
QS3245QG8 Applications
There are a lot of Integrated Device Technology (IDT) QS3245QG8 Signal Switches / Multiplexers / Decoders applications.
- RF-based home automation system
- Communication system
- Memory chips
- Injectors
- Microprocessor input/output systems
- Enabling block of memory depending on address in memory chips
- PCIe
- Analog, digital or video signal switching
- Speed synchronization of multiple motors in industries
- Computer memory
