QS3VH244PAG
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Package / Case | TSSOP |
| Number of Pins | 20 |
| Published | 2008 |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| ECCN Code | EAR99 |
| Resistance | 8Ohm |
| Terminal Finish | Matte Tin (Sn) - annealed |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Subcategory | Bus Driver/Transceivers |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 2 |
| Supply Voltage | 2.5V |
| Terminal Pitch | 0.65mm |
| Frequency | 20MHz |
| Pin Count | 20 |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 3.6V |
| Min Supply Voltage | 2.3V |
| Number of Ports | 2 |
| Nominal Supply Current | 4mA |
| Number of Bits | 8 |
| Propagation Delay | 200 ps |
| Quiescent Current | 4mA |
| Turn On Delay Time | 8 ns |
| Output Characteristics | 3-STATE |
| Supply Type | Single |
| Bandwidth | 500MHz |
| Output Polarity | TRUE |
| Logic IC Type | BUS DRIVER |
| Low Level Output Current | 120mA |
| Independent Circuits | 2 |
| Length | 6.5mm |
| Width | 4.4mm |
| Thickness | 1mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
QS3VH244PAG Overview
As a means of saving space, digital switch is provided in the TSSOP.There is a design for terminating 20 as part of its basic configuration.The multiplexer's system is powered by 2.5V volts.A component pin count of 20 is found on this turn signal switch.GULL WING represents the end of conductors.The supply type of this multiplexer ic is Single.The board is configured with 20 pins.The multiplexer ic is mounted in the direction of Surface Mount.As a result, signal multiplexer provides a total of 8 bits.The digital switch ic is a part of an electronic system classified as Bus Driver/Transceivers.In the absence of external influences, it consumes 4mA current of multiplexer ic.2 ports are used for some other peripheral signal switchings to plug in.With a resistance of 8Ohm, it operates.Signal switch operation at 85°C temperature is acceptable.It is recommended that the minimal operating temperature of the multiplexer be maintained at -40°C.The device is specified to operate at the maximum supply voltage of 3.6V in accordance with its applicable specification.A minimum supply voltage of 2.3V is specified for the digital swith by its applicable specification.It employs BUS DRIVER as its logic IC.
QS3VH244PAG Features
Supplied in the TSSOP package
Adopting a supply type of Single
BUS DRIVER as the logic IC
QS3VH244PAG Applications
There are a lot of Integrated Device Technology (IDT) QS3VH244PAG Signal Switches / Multiplexers / Decoders applications.
- To select different task for memory in microprocessor memory systems
- Home automation system
- Microprocessor instruction decoding
- Enabling block of memory depending on address in memory chips
- Idle motor
- Encrypted communications system
- GLAN
- Decimal decoder
- Time division multiplexing system
- Paper plants
