RT9715AGB
| Parameters | |
|---|---|
| Mounting Type | Surface Mount |
| Package / Case | SC-74A, SOT-753 |
| Surface Mount | YES |
| Number of Pins | 5 |
| Operating Temperature | -40°C~100°C TJ |
| Packaging | Tape & Reel (TR) |
| Published | 2011 |
| Feature | Load Discharge, Status Flag |
| Part Status | Obsolete |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Resistance | 90mOhm |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.939mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 2A |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~5.5V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Output Peak Current Limit-Nom | 2.5A |
| Rds On (Typ) | 90m Ω |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
RT9715AGB Overview
As a result, it is packaged in the form of a Tape & Reel (TR).There is a SC-74A, SOT-753 package that includes it.The LED driver is mounted as Surface Mount.It owns USB Switch switch type.It is recommended that the temperature be set to -40°C~100°C TJ for reliable performance.The LED driver is equipped with 1 outputs.Operation is based on a supply voltage of Not Required.It has a maximum output voltage of N-Channel volts.As far as features are concerned, the LED driving board has Load Discharge, Status Flag.The termination count is 5.In order to operate, 5 pins are used.Currently, there are 1 functions associated with the lighting driver.The maximum output current is reduced to 2A to meet the operation criteria.Supply voltages of 5V allow for high efficiency.Lighting drivers with 90mOhm resistance are used.In order to operate normally, the supply voltage (Vsup) must remain above 2.7V.
RT9715AGB Features
Supplied from 5V
Resistance of 90mOhm
RT9715AGB Applications
There are a lot of Richtek USA Inc. RT9715AGB Power Switches ICs applications.
- Telecom and Network Systems
- Notebook and Tablet Computers
- Hard Disk Drives
- Gaming
- Hot Swap
- USB Power Distribution
- Hot-Swap Systems
- Set-Top Boxes
- Portable GPS
- HDD and SSD
