RT9742ANGJ5F
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-5 Thin, TSOT-23-5 |
| Surface Mount | YES |
| Number of Pins | 23 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2016 |
| Feature | Status Flag |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Resistance | 55mOhm |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.939mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G5 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 3A |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~6V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Output Peak Current Limit-Nom | 3.3A |
| Rds On (Typ) | 55m Ω |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 2.8955mm |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
RT9742ANGJ5F Overview
As you can see, it's packaged in the way of a Cut Tape (CT).The SOT-23-5 Thin, TSOT-23-5 package contains it.The lighting driver is mounted in the Surface Mount position.There is a switch type of USB Switch.It is recommended that the temperature be set to -40°C~85°C TA for reliable operation.By default, it is set to output 1.In order to operate, it requires a voltage supply of Not Required.A maximum output voltage of N-Channel volts can be achieved by this LED driver.It is equipped with Status Flag features.It contains 5 terminations.23 pins are used for operation.It consists of 1 functions.As a result, the maximum output current is reduced to 3A in order to meet the operation requirements.Using a voltage of 5V allows for high efficiency.55mOhm is the resistance of the lighting driver.The maximum supply voltage is set to 6V.In order for this lighting driver to operate normally, the supply voltage (Vsup) should remain above 2.7V.
RT9742ANGJ5F Features
Supplied from 5V
Resistance of 55mOhm
RT9742ANGJ5F Applications
There are a lot of Richtek USA Inc. RT9742ANGJ5F Power Switches ICs applications.
- Wearable Devices
- USB Power Distribution
- Hard Disk Drives
- Portable/Handheld Devices
- Various applications equipped with buttons
- USB Power Distribution
- Set-Top Boxes
- Wireless Modem Data Cards
- Hot-Swap Systems
- Set-top-box
