RT9742ENGJ5
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | SOT-23-5 Thin, TSOT-23-5 |
| Surface Mount | YES |
| Number of Pins | 23 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| Published | 2016 |
| Feature | Status Flag |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 3 (168 Hours) |
| Number of Terminations | 5 |
| ECCN Code | EAR99 |
| Resistance | 70mOhm |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 0.939mm |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| JESD-30 Code | R-PDSO-G5 |
| Number of Outputs | 1 |
| Output Type | N-Channel |
| Max Output Current | 1.5A |
| Supply Voltage-Max (Vsup) | 6V |
| Supply Voltage-Min (Vsup) | 2.7V |
| Interface | On/Off |
| Output Configuration | High Side |
| Voltage - Supply (Vcc/Vdd) | Not Required |
| Input Type | Non-Inverting |
| Switch Type | USB Switch |
| Ratio - Input:Output | 1:1 |
| Voltage - Load | 2.7V~6V |
| Fault Protection | Current Limiting (Fixed), Over Temperature, Reverse Current, UVLO |
| Output Peak Current Limit-Nom | 1.65A |
| Rds On (Typ) | 70m Ω |
| Built-in Protections | OVER CURRENT; THERMAL; UNDER VOLTAGE |
| Output Current Flow Direction | SINK |
| Length | 2.8955mm |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
RT9742ENGJ5 Overview
Cut Tape (CT) is the way it's packaged.Package SOT-23-5 Thin, TSOT-23-5 contains it.It has been mounted as Surface Mount on the LED driver.USB Switch is the switch type it owns.It is recommended that the temperature be set to -40°C~85°C TA for reliable performance.By default, it is set to output 1.To operate, it needs a supply voltage of Not Required.It has a maximum output voltage of N-Channel volts.Features of the lighting driver are Status Flag.The termination count is 5.During operation, the 23 pins are used.It is important to note that the LED driving board has 1 functions.This operation requires the maximum output current to be decreased to 1.5A.It is possible to obtain high efficiency with a supply voltage of 5V.It has 70mOhm resistance.This LED driver is configured to have a maximum supply voltage of 6V (Vsup).In order to operate normally, the supply voltage (Vsup) must remain above 2.7V.
RT9742ENGJ5 Features
Supplied from 5V
Resistance of 70mOhm
RT9742ENGJ5 Applications
There are a lot of Richtek USA Inc. RT9742ENGJ5 Power Switches ICs applications.
- Portable/Handheld Devices
- Notebook PC
- Storage Drives
- Telecom and Network Systems
- Wireless/Networking Cards
- Portable GPS Device
- USB3.1 Power Delivery
- Set-top-box
- USB Ports/Hubs
- Low Voltage I/O System Power
