SN74HC161N3
| Parameters | |
|---|---|
| Package / Case | PDIP |
| Surface Mount | NO |
| Number of Pins | 16 |
| Pbfree Code | no |
| Number of Terminations | 16 |
| Additional Feature | RCO OUTPUT |
| Subcategory | Counters |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Temperature (Max) | 85°C |
| Supply Voltage-Max (Vsup) | 6V |
| Power Supplies | 2/6V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 2V |
| Number of Bits | 4 |
| Family | HC/UH |
| Logic IC Type | BINARY COUNTER |
| Trigger Type | POSITIVE EDGE |
| Propagation Delay (tpd) | 255 ns |
| fmax-Min | 29 MHz |
| Count Direction | UP |
| Load/Preset Input | YES |
| Mode of Operation | SYNCHRONOUS |
| Height Seated (Max) | 5.08mm |
| Length | 19.305mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
SN74HC161N3 Overview
It is a device supplied in the PDIP package. 16 terminations are used for its configuration. Having a supply voltage of 5V enables to operate in a fully flexible manner. In all, there are 16 pins on each component. Circuit components are connected with 16pins. It is a member of the family [0]. This device contains information in 4bits. As far as Pbfree code is concerned, the result may be no. It is important to note that in regards to this electronic device, RCO OUTPUTis an extremely significant feature. The device is manufactured at a temperature grade of INDUSTRIAL. There is 2/6V voltage comes from the voltage source. Supply voltages can be as low as 2V volts (Vsup). Depending on the device type, the maximum supply voltage (Vsup) can be up to 6V volts. In this case, the electronic components belong to the family of [0]. It uses a logic IC type of [0]. The maximum operating temperature is usually set at 85°C.
SN74HC161N3 Features
Embedded in the PDIP package
RCO OUTPUT
BINARY COUNTER as logic IC type
SN74HC161N3 Applications
There are a lot of Texas Instruments SN74HC161N3 Counters & Dividers applications.
- Programmable decade counters
- Time Out Timer for Consumer-Application Industrial Controls
- Time delay circuits
- counting/frequency sy nthesizers-BCD output
- ANALOG SIGNAL PROCESSING
- Fixed and programmable divide-by-10,9,8,7,6,5,4,3,2 counters
- Frequency dividing circuits
- Divide-by-N counting
- SQUARE ROOT
- Dual Up Counters
