SN74HC374APWR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) |
| Number of Pins | 20 |
| Weight | 76.997305mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Series | 74HC |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 2V~6V |
| Base Part Number | 74HC374 |
| Function | Standard |
| Output Type | Tri-State, Non-Inverted |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Number of Channels | 8 |
| Clock Frequency | 70MHz |
| Propagation Delay | 31 ns |
| Quiescent Current | 8μA |
| Turn On Delay Time | 15 ns |
| Current - Output High, Low | 7.8mA 7.8mA |
| Max Propagation Delay @ V, Max CL | 31ns @ 6V, 50pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3pF |
| Clock Edge Trigger Type | Positive Edge |
| Height | 1mm |
| Length | 6.5mm |
| Width | 4.4mm |
| RoHS Status | ROHS3 Compliant |
SN74HC374APWR Overview
The flip flop is packaged in 20-TSSOP (0.173, 4.40mm Width). D flip flop is included in the Tape & Reel (TR)package. The output it is configured with uses Tri-State, Non-Inverted. The trigger configured with it uses Positive Edge. Surface Mountmounts this electrical part. The JK flip flop operates with an input voltage of 2V~6V volts. In the operating environment, the temperature is -40°C~85°C TA. Logic flip flops of this type are classified as D-Type. FPGAs belonging to the 74HCseries contain this type of chip. Its output frequency should not exceed 70MHz Hz. D latch consists of 1 elements. The object belongs to the 74HC374 family. Its input capacitance is 3pF farads. Electronic part Surface Mountis mounted in the way. With its 20pins, it is designed to work with most electronic flip flops. Edge triggering is a type of triggering that allows a circuit to become active at the positive edge or the negative edge of the clock signal. The clock edge trigger type of this device is Positive Edge. If high efficiency is desired, the supply voltage should be kept at 5V. There is 8μA quiescent current consumption by it. The number of channels is growing strong/weak: 8.
SN74HC374APWR Features
Tape & Reel (TR) package
74HC series
20 pins
SN74HC374APWR Applications
There are a lot of Texas Instruments SN74HC374APWR Flip Flops applications.
- Guaranteed simultaneous switching noise level
- QML qualified product
- Control circuits
- Patented noise
- Modulo – n – counter
- Shift registers
- Single Up Count-Control Line
- Count Modes
- Convert a momentary switch to a toggle switch
- Safety Clamp
