SN74HC4017N
| Parameters | |
|---|---|
| Package / Case | PDIP |
| Surface Mount | NO |
| Pbfree Code | no |
| Number of Terminations | 16 |
| HTS Code | 8542.39.00.01 |
| Subcategory | Counters |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | THROUGH-HOLE |
| Peak Reflow Temperature (Cel) | NOT SPECIFIED |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Terminal Pitch | 2.54mm |
| Reach Compliance Code | not_compliant |
| Time@Peak Reflow Temperature-Max (s) | NOT SPECIFIED |
| Pin Count | 16 |
| Qualification Status | Not Qualified |
| Operating Temperature (Max) | 85°C |
| Operating Temperature (Min) | -40°C |
| Supply Voltage-Max (Vsup) | 6V |
| Power Supplies | 2/6V |
| Temperature Grade | INDUSTRIAL |
| Supply Voltage-Min (Vsup) | 2V |
| Load Capacitance | 50pF |
| Number of Bits | 10 |
| Family | HC/UH |
| Logic IC Type | RING COUNTER |
| Max I(ol) | 0.0052 A |
| Trigger Type | POSITIVE EDGE |
| Propagation Delay (tpd) | 290 ns |
| fmax-Min | 29 MHz |
| Count Direction | UP |
| Max Frequency@Nom-Sup | 25000000Hz |
| Load/Preset Input | NO |
| Mode of Operation | SYNCHRONOUS |
| Height Seated (Max) | 5.08mm |
| Length | 19.305mm |
| Width | 7.62mm |
| RoHS Status | Non-RoHS Compliant |
| Lead Free | Contains Lead |
SN74HC4017N Overview
This device is supplied in the PDIP package. In order to configure it, it uses 16terminations. The supply voltage of 5V permits it to operate with full flexibility. There are a total of 16 pins in all components. In this case, it belongs to the family of [0]. As far as the device is concerned, there are 10bits of information. Based on the Pbfree code, the result may be no. A temperature grade of INDUSTRIALis specified for this device. Voltage from the voltage source is [0]. Supply voltage (Vsup) can be as low as 2V. A maximum supply voltage (Vsup) is available up to 6V. It is part of the Countersfamily of electronic components. It uses a logic IC type of [0]. As a general rule, the maximum operating temperature is set to 85°C. As a general rule, it is recommended that the minimum operating temperature be set to -40°C.
SN74HC4017N Features
Embedded in the PDIP package
RING COUNTER as logic IC type
SN74HC4017N Applications
There are a lot of Texas Instruments SN74HC4017N Counters & Dividers applications.
- Divide-by-N counting
- Timers
- Fixed or Programmable Frequency Division
- TRUE RMS-TO-DC CONVERSION
- DIVISION
- Timing applications
- Signal gating
- Fixed and programmable divide-by-10,9,8,7,6,5,4,3,2 counters
- Control counters
- POWER COMPUTATION
