banner_page

SN74HC4040N3

5V CMOS DUAL Counters & Dividers 16 Pins NEGATIVE EDGE PDIP


  • Manufacturer: Texas Instruments
  • Nocochips NO: 815-SN74HC4040N3
  • Package: PDIP
  • Datasheet: -
  • Stock: 755
  • Description: 5V CMOS DUAL Counters & Dividers 16 Pins NEGATIVE EDGE PDIP(Kg)

Details

Tags

Parameters
Package / Case PDIP
Surface Mount NO
Number of Pins 16
Pbfree Code no
Number of Terminations 16
HTS Code 8542.39.00.01
Subcategory Counters
Technology CMOS
Terminal Position DUAL
Terminal Form THROUGH-HOLE
Peak Reflow Temperature (Cel) NOT SPECIFIED
Number of Functions 1
Supply Voltage 5V
Terminal Pitch 2.54mm
Reach Compliance Code not_compliant
Time@Peak Reflow Temperature-Max (s) NOT SPECIFIED
Pin Count 16
Qualification Status Not Qualified
Operating Temperature (Max) 85°C
Operating Temperature (Min) -40°C
Supply Voltage-Max (Vsup) 6V
Power Supplies 2/6V
Temperature Grade INDUSTRIAL
Supply Voltage-Min (Vsup) 2V
Number of Bits 12
Family HC/UH
Logic IC Type BINARY COUNTER
Trigger Type NEGATIVE EDGE
Propagation Delay (tpd) 190 ns
fmax-Min 25 MHz
Count Direction UP
Load/Preset Input NO
Mode of Operation ASYNCHRONOUS
Height Seated (Max) 5.08mm
Length 19.305mm
Width 7.62mm
RoHS Status Non-RoHS Compliant
Lead Free Contains Lead

SN74HC4040N3 Overview


A device of this type is supplied in a package of type [0]. The configuration of this device is based on 16terminations. Having a supply voltage of 5V enables to operate in a fully flexible manner. All component pins are equal to 16. To connect the circuit's other components, there are 16pins. The HC/UHfamily is derived from it. The device contains 12bits of information. Based on the Pbfree code, the result may be no. A temperature grade of INDUSTRIALis specified for this device. From the voltage source, there is a voltage of 2/6V volts. It is possible to supply the device with the minimum supply voltage (Vsup) of 2V. A maximum supply voltage (Vsup) is available up to 6V. In this case, the electronic components belong to the family of [0]. BINARY COUNTER is the logic IC type it uses. A temperature of 85°Cis usually set as the maximum operating temperature. In most cases, a minimum operating temperature of -40°Cis set.

SN74HC4040N3 Features


Embedded in the PDIP package
BINARY COUNTER as logic IC type

SN74HC4040N3 Applications


There are a lot of Texas Instruments SN74HC4040N3 Counters & Dividers applications.

  • Timing applications
  • SQUARE ROOT
  • Clocks
  • counting/frequency sy nthesizers-BCD output
  • ALGEBRAIC COMPUTATION
  • Frequency dividing circuits
  • Dual Up Counters
  • VHF, UHF, FM, AM, etc.
  • Divide-by"N" counters/frequency synthesizers
  • TRUE RMS-TO-DC CONVERSION

Write a review

Note: HTML is not translated!
    Bad           Good