SN74HCT377DWG4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 20 |
| Weight | 500.709277mg |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 20 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 85°C |
| Min Operating Temperature | -40°C |
| Additional Feature | WITH HOLD MODE |
| Subcategory | FF/Latches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Frequency | 37MHz |
| Pin Count | 20 |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | INDUSTRIAL |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 4.5V |
| Load Capacitance | 50pF |
| Propagation Delay | 30 ns |
| Turn On Delay Time | 12 ns |
| Family | HCT |
| Logic Function | D-Type, Flip-Flop |
| Logic IC Type | D FLIP-FLOP |
| Max I(ol) | 0.004 A |
| Number of Bits per Element | 8 |
| High Level Output Current | -4mA |
| Low Level Output Current | 4mA |
| fmax-Min | 22 MHz |
| Clock Edge Trigger Type | Positive Edge |
| Height | 2.35mm |
| Length | 12.8mm |
| Width | 7.52mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
SN74HCT377DWG4 Overview
It is packaged in the way of SOIC. The list contains 1 elements. A total of 20terminations have been recorded. The power supply voltage is 5V. In terms of electronic devices, this device belongs to the HCTfamily of devices. A part of the electronic system is mounted in the way of Surface Mount. There are 20pins on it. This device has the clock edge trigger type of Positive Edge. This device is part of the FF/Latchesbase part number family. It operates from 5V power supplies. In order to ensure high efficiency, the supply voltage should remain at 5V. As an additional reference, you may refer to electronic flip flop WITH HOLD MODE. In this case, the high level output current is set to -4mA. In the low level output current setting, the current is set to 4mA. Operating temperatures should be lower than 85°C. Ideally, the operating temperature should be greater than -40°C. The minimum voltage required for operation is 4.5V. The maximum supply voltage supported by the flip flop is 5.5V. This frequency can be achieved at 37MHz. There is a logic IC D FLIP-FLOP used in the D flip flop. The T flip flop is equipped with 1functions . A total of 20 pins are present on this device.
SN74HCT377DWG4 Features
20 pins
5V power supplies
1 Functions
20 pin count
SN74HCT377DWG4 Applications
There are a lot of Texas Instruments SN74HCT377DWG4 Flip Flops applications.
- Memory
- Counters
- Buffer registers
- Memory
- Count Modes
- Data storage
- Shift registers
- ESCC
- Synchronous counter
- Latch
