SN74HCT574APWR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Mounting Type | Surface Mount |
| Package / Case | 20-TSSOP (0.173, 4.40mm Width) |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| Series | 74HCT |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Type | D-Type |
| Voltage - Supply | 4.5V~5.5V |
| Base Part Number | 74HCT574 |
| Function | Standard |
| Output Type | Tri-State, Non-Inverted |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Clock Frequency | 60MHz |
| Current - Quiescent (Iq) | 8μA |
| Current - Output High, Low | 6mA 6mA |
| Number of Bits per Element | 8 |
| Max Propagation Delay @ V, Max CL | 40ns @ 5.5V, 150pF |
| Trigger Type | Positive Edge |
| Input Capacitance | 3pF |
| RoHS Status | ROHS3 Compliant |
SN74HCT574APWR Overview
It is packaged in the way of 20-TSSOP (0.173, 4.40mm Width). D flip flop is included in the Tape & Reel (TR)package. The output it is configured with uses Tri-State, Non-Inverted. JK flip flop uses Positive Edgeas the trigger. Surface Mountis occupied by this electronic component. With a supply voltage of 4.5V~5.5V volts, it operates. A temperature of -40°C~85°C TAis used in the operation. It is an electronic flip flop with the type D-Type. This type of FPGA is a part of the 74HCT series. It should not exceed 60MHzin its output frequency. A total of 1elements are contained within it. It consumes 8μA of quiescent current without being affected by external factors. It is a member of the 74HCT574 family. This JK flip flop has a 3pFfarad input capacitance.
SN74HCT574APWR Features
Tape & Reel (TR) package
74HCT series
SN74HCT574APWR Applications
There are a lot of Texas Instruments SN74HCT574APWR Flip Flops applications.
- Divide a clock signal by 2 or 4
- Registers
- Modulo – n – counter
- Load Control
- Storage Registers
- Common Clocks
- Power down protection
- Guaranteed simultaneous switching noise level
- Digital electronics systems
- Consumer
