SN74LS174DG4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 16 |
| Weight | 141.690917mg |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FF/Latches |
| Technology | TTL |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Frequency | 40MHz |
| Pin Count | 16 |
| Output Type | TTL |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Current - Output | 8mA |
| Propagation Delay | 30 ns |
| Turn On Delay Time | 20 ns |
| Family | LS |
| Logic Function | D-Type, Flip-Flop |
| Logic IC Type | D FLIP-FLOP |
| Max I(ol) | 0.008 A |
| Number of Bits per Element | 6 |
| High Level Output Current | -400μA |
| Low Level Output Current | 8mA |
| fmax-Min | 30 MHz |
| Clock Edge Trigger Type | Positive Edge |
| Height | 1.58mm |
| Length | 9.9mm |
| Width | 3.91mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
SN74LS174DG4 Overview
The flip flop is packaged in a case of SOIC. This output is configured with TTL. The list contains 1 elements. Terminations are 16. A voltage of 5V is used as the power supply for this D latch. An electronic device belonging to the family LScan be found here. A part of the electronic system is mounted in the way of Surface Mount. It is designed with 16 pins. A Positive Edgeclock edge trigger is used in this device. This device has the base part number FF/Latches. The D latch operates on 5V volts. In order to ensure high efficiency, the supply voltage should remain at 5V. It is set to -400μAfor the high level output current. It is set to 8mAfor low level output current. A temperature below 70°Cshould be used for operation. It is recommended that the operating temperature is higher than 0°C. The minimal supply voltage is 4.75V. 5.25Vis the maximum supply voltage supported by it. This can be achieved at a frequency of 40MHz. D FLIP-FLOPis used as the logic IC in this D flip flop. There are 1 functions available on this T flip flop. 16pins are provided on the D latch. This flip flop features a maximum design flexibility due to its output current of 8mA.
SN74LS174DG4 Features
16 pins
5V power supplies
1 Functions
16 pin count
SN74LS174DG4 Applications
There are a lot of Texas Instruments SN74LS174DG4 Flip Flops applications.
- Single Down Count-Control Line
- Consumer
- Patented noise
- Set-reset capability
- Pattern generators
- ATE
- Test & Measurement
- Data transfer
- Balanced Propagation Delays
- Computers
