SN74LS175DG4
| Parameters | |
|---|---|
| Mount | Surface Mount |
| Package / Case | SOIC |
| Number of Pins | 16 |
| Weight | 141.690917mg |
| JESD-609 Code | e4 |
| Moisture Sensitivity Level (MSL) | 1 |
| Number of Terminations | 16 |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Max Operating Temperature | 70°C |
| Min Operating Temperature | 0°C |
| Subcategory | FF/Latches |
| Technology | TTL |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 5V |
| Frequency | 40MHz |
| Pin Count | 16 |
| Output Type | TTL |
| Operating Supply Voltage | 5V |
| Number of Elements | 1 |
| Polarity | Non-Inverting |
| Power Supplies | 5V |
| Temperature Grade | COMMERCIAL |
| Max Supply Voltage | 5.25V |
| Min Supply Voltage | 4.75V |
| Current - Output | 8mA |
| Propagation Delay | 25 ns |
| Turn On Delay Time | 13 ns |
| Family | LS |
| Logic Function | D-Type, Flip-Flop |
| Logic IC Type | D FLIP-FLOP |
| Max I(ol) | 0.008 A |
| Number of Bits per Element | 4 |
| High Level Output Current | -400μA |
| Low Level Output Current | 8mA |
| fmax-Min | 30 MHz |
| Clock Edge Trigger Type | Positive Edge |
| Height | 1.58mm |
| Length | 9.9mm |
| Width | 3.91mm |
| Radiation Hardening | No |
| RoHS Status | RoHS Compliant |
| Lead Free | Lead Free |
SN74LS175DG4 Overview
SOICis the way it is packaged. There is a TTLoutput configured with it. D latch consists of 1 elements. A total of 16terminations have been recorded. The D flip flop is powered by a voltage of 5V . This D flip flop belongs to the family of LS. It is mounted by the way of Surface Mount. 16pins are included in its design. Its clock edge trigger type is Positive Edge. This device is part of the FF/Latchesbase part number family. A total of 5V power supplies are needed to run it. Optimal efficiency requires a supply voltage of 5V. -400μAis set as the high level output current. In the low level output current setting, 8mAis used. It is recommended that the operating temperature be lower than 70°C. It is recommended that the operating temperature is higher than 0°C. It is powered by 4.75V as its minimum supply voltage. There is a maximum voltage support of 5.25V. A frequency of 40MHzcan be achieved. The logic IC it adopts is D FLIP-FLOP. There are 1 functions associated with the JK flip flop. It is equipped with 16 pins. With an output current of 8mA, this flip flop offers maximum design flexibility.
SN74LS175DG4 Features
16 pins
5V power supplies
1 Functions
16 pin count
SN74LS175DG4 Applications
There are a lot of Texas Instruments SN74LS175DG4 Flip Flops applications.
- Consumer
- Pattern generators
- EMI reduction circuitry
- Data Synchronizers
- Modulo – n – counter
- CMOS Process
- Registers
- Cold spare funcion
- Frequency Divider circuits
- Synchronous counter
