SN74LV4051ADR
| Parameters | |
|---|---|
| Width | 3.91mm |
| Thickness | 1.58mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 5 days ago) |
| Contact Plating | Gold |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 16-SOIC (0.154, 3.90mm Width) |
| Number of Pins | 16 |
| Weight | 141.690917mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Cut Tape (CT) |
| JESD-609 Code | e3 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 100Ohm |
| Terminal Finish | Matte Tin (Sn) |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Terminal Form | GULL WING |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.3V |
| Base Part Number | 74LV4051 |
| Pin Count | 16 |
| Polarity | Non-Inverting |
| Power Supplies | 3.3V |
| Number of Channels | 8 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 20μA |
| Nominal Supply Current | 20mA |
| Propagation Delay | 12 ns |
| Turn On Delay Time | 28 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Number of Inputs | 8 |
| Supply Type | Single |
| Bandwidth | 35MHz |
| Supply Current-Max (Isup) | 0.04mA |
| Turn-Off Delay Time | 28 ns |
| On-State Resistance (Max) | 75Ohm |
| High Level Output Current | 25mA |
| Low Level Output Current | 25mA |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 45 dB |
| Current - Leakage (IS(off)) (Max) | 100nA |
| Channel Capacitance (CS(off), CD(off)) | 0.5pF 23.4pF |
| On-state Resistance Match-Nom | 2.1Ohm |
| Switch Time (Ton, Toff) (Max) | 14ns, 14ns |
| Channel-to-Channel Matching (ΔRon) | 1.3 Ω |
| Voltage - Supply, Single (V+) | 2V~5.5V |
| Drain to Source Resistance | 100Ohm |
| Signal Current-Max | 0.05A |
| Height | 1.75mm |
| Length | 9.9mm |
SN74LV4051ADR Overview
Packed in 16-SOIC (0.154, 3.90mm Width), the electronic component is convenient for shipping overseas. High reliability is provided by advanced packaging method Cut Tape (CT). Mounted in Surface Mount is this multiplexer. 8:1 is the number of circuits in the multiplexer and demultiplexer. Operating temperature around -40°C~85°C TA extended. There are 16 terminations totally. Due to its 8 channels, the electrical component produces high-quality output. In the case of a voltage supply of 2.3V volts, the electrical part can be powered up and run. There are 16 pins injected into the electronic part body. The circuits in this analogue multiplexer number 1. Try searching with 74LV4051 if you're looking for variants. As far as internal resistance is concerned, it has 100Ohm. For details about the functions of 16 pins, please refer to the datasheets. The analog multiplexer shown here is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 5.5V. Analogue multiplexers of the Single supply type that are cost-effective. The lowest voltage the electronic part should receive is 2V. The switch device would be able to operate with 20μA current. An analogue multiplexer drains from a single voltage supply at 2V~5.5V. Operating the 8 inputs requires 8 inputs. In 35MHz-bandwidths, data can be transferred. It has a Drain to Source resistance of 100Ohm ohms.
SN74LV4051ADR Features
8 Channels
20μA Supply Current
Bandwidth: 35MHz
Drain-to-Source resistance: 100Ohm
SN74LV4051ADR Applications
There are a lot of Texas Instruments SN74LV4051ADR Analog Switches & Multiplexers ICs applications.
- Communication systems
- Communications systems
- E1 Multiplexer
- Avionics test equipment
- Medical systems
- Data switching
- CSU
- PBXs
- Cross Connects
- SDH
