SN74LV4051AN
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 14 hours ago) |
| Mount | Through Hole |
| Mounting Type | Through Hole |
| Package / Case | 16-DIP (0.300, 7.62mm) |
| Number of Pins | 16 |
| Weight | 951.693491mg |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tube |
| JESD-609 Code | e4 |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 16 |
| ECCN Code | EAR99 |
| Resistance | 75Ohm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | Multiplexer or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.3V |
| Terminal Pitch | 2.54mm |
| Base Part Number | 74LV4051 |
| Output | SEPARATE OUTPUT |
| Pin Count | 16 |
| Polarity | Non-Inverting |
| Power Supplies | 3.3V |
| Number of Channels | 8 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 2V |
| Operating Supply Current | 20μA |
| Nominal Supply Current | 20μA |
| Propagation Delay | 12 ns |
| Turn On Delay Time | 28 ns |
| Logic Function | Demultiplexer, Multiplexer |
| Number of Inputs | 8 |
| Supply Type | Single |
| Bandwidth | 35MHz |
| Supply Current-Max (Isup) | 0.04mA |
| Turn-Off Delay Time | 28 ns |
| On-State Resistance (Max) | 75Ohm |
| Multiplexer/Demultiplexer Circuit | 8:1 |
| Off-state Isolation-Nom | 45 dB |
| Current - Leakage (IS(off)) (Max) | 100nA |
| Channel Capacitance (CS(off), CD(off)) | 0.5pF 23.4pF |
| On-state Resistance Match-Nom | 2.1Ohm |
| Switch Time (Ton, Toff) (Max) | 14ns, 14ns |
| Channel-to-Channel Matching (ΔRon) | 1.3 Ω |
| Voltage - Supply, Single (V+) | 2V~5.5V |
| Drain to Source Resistance | 100Ohm |
| Signal Current-Max | 0.05A |
| Height | 5.08mm |
| Length | 19.3mm |
| Width | 6.35mm |
| Thickness | 3.9mm |
| Radiation Hardening | No |
| REACH SVHC | No SVHC |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
SN74LV4051AN Overview
Presented in 16-DIP (0.300, 7.62mm), this electrical component is convenient for overseas shipping. High reliability is achieved by using advanced packaging method Tube. In Through Hole, this analog switch is mounted. The ratio between the number of multiplexer and demultiplexer circuits is 8:1. Operating temperature around -40°C~85°C TA extended. In total, 16 terminations have occurred. High-quality output is provided by the electronic component's 8 channels. With a 2.3V voltage supply, the electrical component should be turned on and run. Electronic part bodies are injected with 16 pins. This multiplexer is composed of 1 circuits. Look for analog switch ic variants by searching with 74LV4051. In this multiplexer, the internal resistance is 75Ohm. To find out what the functions of 16 pins are, please refer to their datasheets. It is a typical Multiplexer or Switches analog multiplexer. A voltage higher than 5.5V should not normally be supplied to the switches. An effective Single supply digital multiplexer. The lowest voltage the electronic part should receive is 2V. 20μA current would be enough for this multiplexer to operate. Using a single voltage supply, this switch device consumes 2V~5.5V volts. The outputs of this digital multiplexer are SEPARATE OUTPUT in number. A 8 input needs to be operated. This switch operates within the bandwidth of 35MHz. This electronic component presents a Drain to Source resistance of 100Ohm.
SN74LV4051AN Features
8 Channels
20μA Supply Current
Bandwidth: 35MHz
Drain-to-Source resistance: 100Ohm
SN74LV4051AN Applications
There are a lot of Texas Instruments SN74LV4051AN Analog Switches & Multiplexers ICs applications.
- Audio and video switching
- Short/Medium Loop: approximately 2000 ft. of 26 AWG and 5 REN loads
- Microprocessor Controlled Analog Systems
- Medical systems
- Fault Tolerant Systems
- Audio/video switches
- Frame Relay Equipment
- Multiplexers
- Signal routing between systems
- PBXs
