SN74LV4066ADGVR

12ns, 12ns SPST - NO 75Ohm DUAL Analog Switches MAKE-BEFORE-BREAK 74LV4066 14 Pins 100nA 2.3V 14-TFSOP (0.173, 4.40mm Width)

Manufacturer: Texas Instruments
Nocochips NO: 815-SN74LV4066ADGVR
Package: 14-TFSOP (0.173, 4.40mm Width)
Datasheet: PDF
Stock: 483
Description: 12ns, 12ns SPST - NO 75Ohm DUAL Analog Switches MAKE-BEFORE-BREAK 74LV4066 14 Pins 100nA 2.3V 14-TFSOP (0.173, 4.40mm Width)(Kg)

Inquiry Now

Details

Tags

Parameters
Factory Lead Time	1 Week
Lifecycle Status	ACTIVE (Last Updated: 2 days ago)
Mount	Surface Mount
Mounting Type	Surface Mount
Package / Case	14-TFSOP (0.173, 4.40mm Width)
Number of Pins	14
Weight	41.787197mg
Operating Temperature	-40°C~85°C TA
Packaging	Tape & Reel (TR)
JESD-609 Code	e4
Pbfree Code	yes
Part Status	Active
Moisture Sensitivity Level (MSL)	1 (Unlimited)
Number of Terminations	14
ECCN Code	EAR99
Resistance	75Ohm
Terminal Finish	Nickel/Palladium/Gold (Ni/Pd/Au)
Subcategory	Multiplexer or Switches
Technology	CMOS
Terminal Position	DUAL
Terminal Form	GULL WING
Peak Reflow Temperature (Cel)	260
Number of Functions	4
Supply Voltage	2.3V
Base Part Number	74LV4066
Output	SEPARATE OUTPUT
Pin Count	14
Power Supplies	2.5/5V
Number of Channels	4
Max Supply Voltage	5.5V
Min Supply Voltage	2V
Operating Supply Current	20μA
Max Supply Current	20μA
Throw Configuration	SPST
Propagation Delay	10 ns
Turn On Delay Time	16 ns
Input Voltage (Min)	2V
Supply Type	Single
Bandwidth	50MHz
Turn-Off Delay Time	16 ns
On-State Resistance (Max)	75Ohm
Multiplexer/Demultiplexer Circuit	1:1
Off-state Isolation-Nom	40 dB
Current - Leakage (IS(off)) (Max)	100nA
Channel Capacitance (CS(off), CD(off))	0.5pF 5.5pF
On-state Resistance Match-Nom	6Ohm
Switch Circuit	SPST - NO
Switch Time (Ton, Toff) (Max)	12ns, 12ns
Channel-to-Channel Matching (ΔRon)	2 Ω
Crosstalk	-45dB @ 1MHz
Switching	MAKE-BEFORE-BREAK
Switch-on Time-Max	25ns
Switch-off Time-Max	25ns
Voltage - Supply, Single (V+)	2V~5.5V
Normal Position	NO
Height	1.2mm
Length	3.6mm
Width	4.4mm
Thickness	1.05mm
Radiation Hardening	No
RoHS Status	ROHS3 Compliant
Lead Free	Lead Free

SN74LV4066ADGVR Overview

The electrical component comes in 14-TFSOP (0.173, 4.40mm Width) packaging, which makes it convenient to ship overseas. High reliability is ensured by the advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. 1:1 is the ratio between multiplexers and demultiplexers. An extended operating temperature of -40°C~85°C TA degrees Celsius. Total terminations are 14. A high-quality output is provided by the electrical component's 4 channels. Powered by a 2.3V voltage supply, the electrical part should be switched on and run. This electronic part can be found in the 14 series. Circuits based on SPST - NO switching are used to construct these analog switch ics. Try searching for the analog switch ic with 74LV4066 if you are looking for variants. An switch multiplexer with 75Ohm internal resistance has a value of 75Ohm. Datasheets for 14 pin functions are available upon request. Theswitch device is a typical Multiplexer or Switches. normally, users should not supply switches with voltages higher than 5.5V. The digital multiplexer has a low cost Single supply. It is recommended to use 2V as the lowest voltage for the electrical part. 20μA current would be enough for this multiplexer to operate. Analogue multiplexers require a 2V~5.5V voltage to drain from a single voltage supply. If you put voltage higher than 20μA on the digital multiplexer, damage may occur. There are SEPARATE OUTPUT outputs on this analog switch ic. The transfer of data can be performed over 50MHz bandwidths.