SN74LVC1G3157DRYR
| Parameters | |
|---|---|
| Factory Lead Time | 1 Week |
| Lifecycle Status | ACTIVE (Last Updated: 5 days ago) |
| Mount | Surface Mount |
| Mounting Type | Surface Mount |
| Package / Case | 6-UFDFN |
| Number of Pins | 6 |
| Operating Temperature | -40°C~85°C TA |
| Packaging | Tape & Reel (TR) |
| JESD-609 Code | e4 |
| Pbfree Code | yes |
| Part Status | Active |
| Moisture Sensitivity Level (MSL) | 1 (Unlimited) |
| Number of Terminations | 6 |
| ECCN Code | EAR99 |
| Resistance | 15Ohm |
| Terminal Finish | Nickel/Palladium/Gold (Ni/Pd/Au) |
| Subcategory | Multiplexers or Switches |
| Technology | CMOS |
| Terminal Position | DUAL |
| Peak Reflow Temperature (Cel) | 260 |
| Number of Functions | 1 |
| Supply Voltage | 2.3V |
| Terminal Pitch | 0.5mm |
| Base Part Number | 74LVC1G3157 |
| Pin Count | 6 |
| Number of Outputs | 2 |
| Number of Channels | 1 |
| Number of Circuits | 1 |
| Max Supply Voltage | 5.5V |
| Min Supply Voltage | 1.65V |
| Operating Supply Current | 1μA |
| Nominal Supply Current | 1μA |
| Max Supply Current | 10μA |
| Propagation Delay | 300 ps |
| Turn On Delay Time | 5.7 ns |
| Supply Type | Single |
| Bandwidth | 300MHz |
| Turn-Off Delay Time | 3.8 ns |
| -3db Bandwidth | 340MHz |
| On-State Resistance (Max) | 15Ohm |
| Multiplexer/Demultiplexer Circuit | 2:1 |
| Off-state Isolation-Nom | 57 dB |
| Channel Capacitance (CS(off), CD(off)) | 5.2pF |
| On-state Resistance Match-Nom | 0.1Ohm |
| Switch Circuit | SPDT |
| Switch Time (Ton, Toff) (Max) | 5.7ns, 3.8ns |
| Charge Injection | 7pC |
| Channel-to-Channel Matching (ΔRon) | 100m Ω |
| Crosstalk | -54dB @ 10MHz |
| Switching | BREAK-BEFORE-MAKE |
| Switch-off Time-Max | 7.5ns |
| Voltage - Supply, Single (V+) | 1.65V~5.5V |
| Normal Position | NC |
| Height | 600μm |
| Length | 1.45mm |
| Width | 1mm |
| Thickness | 500μm |
| Radiation Hardening | No |
| RoHS Status | ROHS3 Compliant |
| Lead Free | Lead Free |
SN74LVC1G3157DRYR Overview
The electronic component is convenient to ship overseas because it is packed in a 6-UFDFN. High reliability is provided by advanced packaging method Tape & Reel (TR). The multiplexer is located in Surface Mount. Multiplexers and demultiplexers have the same number of circuits 2:1. An extended operating temperature of -40°C~85°C TA degrees Celsius. In total, there have been 6 terminations. Due to its 1 channels, the electrical component produces high-quality output. When the electronic component is given a voltage of 2.3V, it should be turned on and run. There is an electrical component included in the 6 series. Based on SPDT switching circuits, these analog multiplexers work. It consists of 1 circuits. Try searching for the analog switch ic with 74LVC1G3157 if you are looking for variants. This digital multiplexer has 15Ohm internal resistance. For details about the functions of 6 pins, please refer to the datasheets. In this analog multiplexer, the value is Multiplexers or Switches. Multiplexers should not be powered above 5.5V in normal situations. The analog switch ic is of the Single supply type and is cost-effective. 1.65V is the lowest voltage that should be fed to the electronic electronic part. For this multiplexer to operate, 1μA current would be sufficient. A voltage of 1.65V~5.5V is required to drain this analog switch from a single voltage supply. The analogue multiplexer may be damaged if voltage is greater than 10μA. It is possible to transfer data over a 300MHz-bandwidth. 2 outputs are included in the analogue multiplexer.
SN74LVC1G3157DRYR Features
1 Channels
Switch Circuit: SPDT
1μA Supply Current
-3db Bandwidth: 340MHz
Bandwidth: 300MHz
SN74LVC1G3157DRYR Applications
There are a lot of Texas Instruments SN74LVC1G3157DRYR Analog Switches & Multiplexers ICs applications.
- DSUs
- Wireless Local Loop
- Routers
- Cell phones
- Communication systems
- Battery-powered systems
- Industrial
- Digital access cross connects
- RGB switches
- Low-Voltage
